I Nstructions For Assembly - HBM Machines H130191 Bedienungsanleitung

4. Always replace the detachable handle when the tool is not in use.
5. On first time use there may be some smoke, this is just grease used in manufacturing or foam
residue burning off. It is normal and should only last within 1 minute. It is not harmful to the
product or user.

After operation
1. Turn it off.
2. Unplug it to make sure it won't be turned on accidentally by children or other unexpected
factors.

I nstructions for assembly


The tool is fit with a spool of heating wire. To start assembly, loosen the spool fastener first,
pull out about 20cm of heating wire . Thread the wire through the hole(see pic below) on the
spool, which is very important. Otherwise the spool may be melted by high temperature.

Thread the wire though the hole in the base and tie it in a knot. Then turn the spool to tighten
the heating wire. Finally, re-tighten the spool fastener.
spool fastener
wire angle adjuster

The knot must be pulled inside like the right picture shows below.