Configuration - OHAUS i-DT33P Bedienungsanleitung

EN-10
SETUP
USB Device Function
A. The OHAUS Interface is preset to communicate using the following settings:
9600 baud, 8 bits, no parity, no handshake. Check the USB device
parameters required for the printer or computer that is to be connected. See
the computer or printer documentation if assistance is required. If the
parameters do not match, you will need to change either the indicator's, the
computer's or the printer's settings.
B. Upon installation of the interface, the indicator will recognize the USB device
interface and add relevant items to the menu.

CONFIGURATION

If the USB board is not connected, the submenu will not display.
USB
For printing template setup, please refer to the following table
Reset
Assignment
Print Setup
Template
End
Note: \ refers to not applicable in the table above.
Reset
Baud Rate
Parity
Stop Bit
Handshake
Alt Print CMD
Alt Tare CMD
Alt Zero CMD
End
Stable Weight Only
[Demand]
Mode [Auto On Stable]
Time [Interval(seconds)]
Link to [OH-Continuous]
Checksum [MT-
Continuous]
no, yes
300, 600, 1200, 2400, 4800, 9600,
19200,38400, 57600
7 Even, 7 Odd, 7 None, 8 None
1 bit, 2 bit
None, Xon/Xoff
'A' ~ 'Z', P
'A' ~ 'Z', T
'A' ~ 'Z', Z
\
no, yes
Demand, Auto On Stable, Auto On
Accept, Interval (seconds), MT-
Continuous, OH-Continuous, SICS
Off, On (LFT is forced to be On)
Load, Load and Zero
1~5000
Off, Custom 1, Custom2
On, Off
Custom 1, Custom 2
\