Product Description; Overview; Assembly; Installation - Oase SwimSkim 25 Inbetriebnahme

Product Description

Overview

1 Container
2 Skimmer flap
3 Float (not installed on delivery)
4 Filter basket
5 Foam filter
6 Air distributor for aerating the water
7 Pump chamber with pump

Assembly

 A
• Push the two floats into the channels in the container provided for this purpose until they au-
dibly engage.
• Align the air distributor.
• Place the foam filter and the filter basket in the container.

Installation

 B
• Position the skimmer in the pond and submerge it in water until the pump chamber and con-
tainer are fully flooded.
• Ensure that the skimmer flap is correctly positioned. Ensure that the skimmer flap can move
freely.

Anchor the skimmer to limit its movement range.
− To do so, fasten a cord on the eyelet of the pump chamber. Anchor the other end of the
cord at the edge or bottom of the pond.

Commissioning/start-up

Switching on: Connect the unit to the mains. The unit switches on immediately.
Switching off: Disconnect the unit from the mains.
8
SSM0005