Safety Information - Renkforce 1233874 Bedienungsanleitung

4. Safety Information

The warranty/guarantee will expire if damage is incurred resulting from non-compliance with
these operating instructions. We do not assume liability for any consequential damage.
Nor do we assume any liability for damage to property or personal injury caused by improper
use or failure to observe the safety instructions. In such cases the warranty/guarantee is vo-
ided.
Dear Customer: The following safety information is intended not only for the protection of the
device but also for the protection of your health. Please read the following items carefully:
• For safety reasons, any unauthorized conversions and/or modifications to the product are not
permitted.
• This device is a safety class 1 product. The only permissible voltage source is a properly groun-
ded mains socket (110-240 V/50/60 Hz) of the public mains.
• Check the device for damage before using it. If the device is damaged, do not operate it and
consult an expert or our service team.
• Anyone operating, installing, setting up, commissioning or servicing this effect spotlight must
be trained and qualified properly and observe these operating instructions.
• The mains socket to which the product is connected must be easily accessible.
• Do not use the product inside of rooms or in bad ambient conditions where flammable gases,
vapours or explosive dust may be or are present! There is a danger of explosion!
• LED radiation may be dangerous if the LED beam or a reflection enters the unprotected eye.
Therefore, familiarise yourself with the statutory regulations and measures of precaution for
the operation of this kind of LED device before using the device.
• Never look straight into the light source during operation. The bright light flashes may tem-
porarily impair your eyesight. Apart from this, epileptic fits may be triggered under certain
circumstances in persons sensitive to such lights. This particularly applies to epileptics.
• Never touch the mains plug with wet or damp hands. There is a risk of potentially fatal electric
shock!
• Make sure that the mains cable is not squeezed, bent, damaged by sharp edges or put under
mechanical stress. Avoid excessive thermal stress on the mains cable from extreme heat or
cold. Do not modify the mains cable. Otherwise the mains cable may be damaged. A damaged
mains cable can cause a deadly electric shock.
• Do not touch the mains cable if it is damaged. First, power down the respective mains socket
(e.g. via the respective FI switch and circuit breaker) and then carefully pull the mains plug
from the mains socket. In this case, take the device to a specialist workshop for repair. Never
use the product if the mains cable is damaged.
All manuals and user guides at all-guides.com
23