Product Overview; Using The Tool; Intended Use; Overload Protection - Pattfield Ergo Tools PE-20 IDB Originalbetriebsanleitung

1
2
3
4
5
1
124 EN
8
7
6
2

Product overview

1x
1 Chuck
2 On / Off switch
3 Soft grip
4 LED
5 Battery release switch
6
Battery (not included)
7 Belt clip
8 Rotation direction switch

Using the tool

1. To switch on the tool, press the on / off
switch 2. The deeper the on / off switch 2
is pressed, the faster the impact driver
rotates.
2. Make sure your workpiece can not slip.
Start working, while holding the tool
firmly.
3. To switch off the tool, release the on / off
switch 2.
Warning! If the tool is not in use,
centre the rotation direction switch,
in order to lock the tool.
DE Lieferumfang
FR Etendue de livraison
IT Materiale compreso nella fornitura
NL Leveringsomvang
SV CHARGE BATTERY Leveransomfång
1 Plug the charger (not included) into a
CZ suitable wall socket. Rozsah dodávky
SK Caution! Only use the battery Rozsah dodávky
charger specified in technical data
to charge the battery. RO Volumul livrat
GB Scope of delivery

Intended Use

1x
The tool is intended for driving in and loosen-
ing screws in wood, metal and plastic.
The tool is not intended for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.

Overload protection

When the load is too high or the allowable
battery temperature is exceeded, the mo-
tor comes to a stop. Relieve the load on the
machine immediately and allow cooling for
approx. 30 seconds at the highest no-load
speed.
2 Slide the battery 6 (not included) onto
the charger and check its LED:
Red: Charging
Green: Battery is fully charged
Flashing Red: Battery is defective
Flashing Green: Battery is too hot/ cold
EN 125