Herunterladen Inhalt Inhalt Diese Seite drucken

Personal Safety - UNIPRODO UNI WS 5000PLUS Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für UNI WS 5000PLUS:
Inhaltsverzeichnis

Werbung

DE
b)
Nicht
verwendete
Werkzeuge
sind
außerhalb
der Reichweite von Kindern sowie von Personen
aufzubewahren, welche weder das Gerät noch die
Anleitung kennen. In den Händen unerfahrener
Personen
können
diese
Geräte
eine
Gefahr
darstellen.
c)
Halten Sie das Gerät stets in einem einwandfreien
Zustand. Im Falle eines Schadens muss das Gerät vor
Gebrauch in Reparatur gegeben werden.
d)
Halten Sie das Gerät außerhalb der Reichweite von
Kindern.
e)
Reparatur
und
Wartung
von
Geräten
dürfen
nur
von
qualifiziertem
Fachpersonal
und
Originalersatzteilen
durchgeführt
werden.
Nur
so wird die Sicherheit während der Nutzung
gewährleistet.
f)
Um
die
Funktionsfähigkeit
des
Gerätes
gewährleisten, dürfen die werksmäßig montierten
Abdeckungen oder Schrauben nicht entfernt werden.
g)
Beachten Sie bei Transport zwischen Lager und
Bestimmungsort und Handhabung des Gerätes die
Grundsätze für Gesundheits- und Arbeitsschutz des
Landes, in dem das Gerät verwendet wird. .
h)
Es ist verboten, das Gerät während des Betriebs zu
schieben, umzustellen oder zu drehen.
i)
Das Gerät muss regelmäßig gereinigt werden, damit
sich nicht dauerhaft Schmutz festsetzt.
j)
Das Gerät ist kein Spielzeug. Reinigung und Wartung
dürfen nicht von Kindern ohne Aufsicht durch eine
erwachsene Person durchgeführt werden..
k)
Es ist untersagt, in den Aufbau des Geräts
einzugreifen, um seine Parameter oder Konstruktion
zu ändern.
l)
Geräte von Feuer – und Wärmequellen fernhalten.
m)
Kippen bzw. senken Sie das Gerät während des
Transports, der Installation und des Gebrauchs nicht,
da es dadurch beschädigt werden kann.
n)
Wenn das Gerät längere Zeit ausgeschaltet war,
aktivieren Sie den Regenerationszyklus und drehen
Sie den Hahn einige Minuten auf, bevor Sie den
normalen Betrieb des Geräts wieder aufnehmen;
o)
Wenn Sie das Gerät von der Stromversorgung
trennen, können sich die Einstellungen des Geräts
ändern. Überprüfen Sie nach jedem Stromausfall die
Geräteuhr und andere Parameter.
p)
Wenn sich die Wasserhärte erheblich ändert, sollte
sie im Benutzereinstellungsmenü angepasst bzw.
korrigiert werden.
q)
Heißes Wasser kann das Gerät schwer beschädigen.
Vergewissern Sie sich bei der Verwendung eines
Boilers/ Warmwasserbereiters, dass die Gesamtlänge
der Leitungen zwischen Enthärter und Boiler/
Warmwasserbereiter mindestens 3 Meter beträgt.
Wenn die erforderliche Rohrlänge nicht eingehalten
werden kann, wird es empfohlen, ein Rückschlagventil
zwischen
Filter
und
Boiler/Warmwasserbereiter
einzubauen.
r)
Der Wassereintrittsdruck muss zwischen 1 und 4,5
bar liegen. Ein Unterdruckswert ist nicht erlaubt.
s)
Lassen Sie nicht zu, dass das Gerät einfriert.
t)
Vergewissern Sie sich, dass bei Undichtigkeiten
Wasser im Boden in der Nähe des Geräts austritt.
u)
Setzen Sie das Produkt keinem mechanischen Druck
aus.
v)
Setzen Sie das Gerät keinem direkten Sonnenlicht
aus.
w)
Schließen Sie das Gerät erst an die Stromversorgung
an, wenn alle Arbeiten an der Wasserinstallation
abgeschlossen sind.
4
x)
Tragen Sie das Gerät nicht an Schläuchen, Ventilen,
Anschlüssen und anderen empfindlichen Bauteilen
der Steuerung
y)
Die Steckdose, an die das Gerät angeschlossen wird,
muss über ein Erdungskabel verfügen.
z)
Es darf nur normales Leitungswasser an das Gerät
angeschlossen werden.
aa)
Trinken Sie kein Wasser direkt aus dem Gerät.
bb)
Die Wassertemperatur am Geräteeingang darf 38°C
nicht überschreiten.
cc)
Verwenden Sie das Gerät nicht bei Temperaturen
unter 5°C.
mit
ACHTUNG! Obwohl das Gerät in Hinblick auf Sicherheit
entworfen wurde und über Schutzmechanismen
sowie
zusätzlicher
Sicherheitselemente
besteht bei der Bedienung eine geringe Unfall-
zu
oder Verletzungsgefahr. Es wird empfohlen, bei der
Nutzung Vorsicht und Vernunft walten zu lassen.
U S E R M A N U A L
LEGEND
The product satisfies the relevant safety standards.
Read instructions before use.
The product must be recycled.
WARNING! or CAUTION! or REMEMBER! Applicable
to the given situation (general warning sign).
ATTENTION! Electric shock warning!
Only use indoors.
USAGE SAFETY
verfügt,
ATTENTION! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in serious injury or even
death.
The terms "device" or "product" are used in the warnings
and instructions to refer to ALL-IN-ONE WATER SOFTENER
FILTER. Prevent the device from getting wet. Risk of electric
shock! Do not exceed the maximum permissible operating
pressure!
ELECTRICAL SAFETY
a)
The plug must fit the socket. Do not modify the plug
in any way. Using original plugs and matching sockets
reduces the risk of electric shock.
b)
Avoid touching earthed elements such as pipes,
heaters, boilers and refrigerators. There is an
increased risk of electric shock if the earthed device is
exposed to rain, comes into direct contact with a wet
surface or is operating in a damp environment. Water
getting into the device increases the risk of damage to
the device and of electric shock.
c)
Do not touch the device with wet or damp hands.
d)
Use the cable only for its designated use. Never use it
to carry the device or to pull the plug out of a socket.
Keep the cable away from heat sources, oil, sharp
edges or moving parts. Damaged or tangled cables
increase the risk of electric shock.
e)
If using the device in a damp environment cannot be
avoided, a residual current device (RCD) should be
applied. The use of an RCD reduces the risk of electric
shock.
f)
Do not use the device if the power cord is damaged or
shows obvious signs of wear. A damaged power cord
should be replaced by a qualified electrician or the
manufacturer's service centre.
g)
To avoid electric shock, do not immerse the cord,
plug or device in water or other liquids. Do not use
the device on wet surfaces.
h)
The power cord connected to the appliance must be
properly grounded and correspond to the technical
details on the product label.
SAFETY IN THE WORKPLACE
a)
Make sure the workplace is clean and well lit. A messy
or poorly lit workplace may lead to accidents. Try
to think ahead, observe what is going on and use
common sense when working with the device.
b)
Do not use the device in a potentially explosive
environment, for example in the presence of
flammable liquids, gases or dust. The device
generates sparks which may ignite dust or fumes.
c)
If you discover damage or irregular operation,
immediately switch the device off and report it to
a supervisor without delay.
d)
If there are any doubts as to the correct operation
of the device, contact the manufacturer's support
service.
5
EN
e)
Only the manufacturer's service point may repair the
device. Do not attempt any repairs independently!
f)
In case of fire, use a powder or carbon dioxide
(CO
) fire extinguisher (one intended for use on live
2
electrical devices) to put it out.
g)
Regularly inspect the condition of the safety labels. If
the labels are illegible, they must be replaced.
h)
Please keep this manual available for future
reference. If this device is passed on to a third party,
the manual must be passed on with it.
i)
Keep packaging elements and small assembly parts in
a place not available to children.
j)
Keep the device away from children and animals.
k)
If this device is used together with another
equipment, the remaining instructions for use shall
also be followed.
REMEMBER! When using the device, protect children
and other bystanders.

PERSONAL SAFETY

a)
Do not use the device when tired, ill or under the
influence of alcohol, narcotics or medication which
can significantly impair the ability to operate the
device.
b)
The device is not designed to be handled by persons
(including children) with limited mental and sensory
functions or persons lacking relevant experience and/
or knowledge unless they are supervised by a person
responsible for their safety or they have received
instruction on how to operate the device.
c)
When working with the device, use common sense
and stay alert. Temporary loss of concentration while
using the device may lead to serious injuries.
d)
The device is not a toy. Children must be supervised
to ensure that they do not play with the device.
SAFE DEVICE USE
a)
Disconnect the device from the power supply
before commencement of adjustment, cleaning and
maintenance. Such a preventive measure reduces the
risk of accidental activation.
b)
When not in use, store in a safe place, away from
children and people not familiar with the device who
have not read the user manual. The device may pose
a hazard in the hands of inexperienced users.
c)
Keep the device in perfect technical condition. If
damage is discovered, hand over the device for repair
before use.
d)
Keep the device out of the reach of children.
e)
Device repair or maintenance should be carried out
by qualified persons, only using original spare parts.
This will ensure safe use.
f)
To ensure the operational integrity of the device, do
not remove factory-fitted guards and do not loosen
any screws.
g)
When transporting and handling the device between
the warehouse and the destination, observe the
occupational health and safety principles for manual
transport operations which apply in the country
where the device will be used.
h)
Do not move, adjust or rotate the device in the course
of work.
i)
Clean the device regularly to prevent stubborn grime
from accumulating.
j)
The device is not a toy. Cleaning and maintenance may
not be carried out by children without supervision by
an adult person.
k)
It is forbidden to interfere with the structure of
the device in order to change its parameters or
construction.

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für UNIPRODO UNI WS 5000PLUS

Inhaltsverzeichnis