Taurus HS-2900 Bedienungsanleitung Seite 9

English
BATTERY UP-RIGHT VACUUM CLEANER
HS-2900
DESCRIPTION
A Accessory 2 in 1:
A-1 Upholstery brush.
A-2 Lance
B Button to remove the tank.
C Dust tank.
D Extension tube.
E Motorized brush
E-1 Bristle brush for carpets and rugs
E-2 Powder brush for hard floors
F Brush release button.
G Cyclone and sponge filter.
H Battery status indicator
I Lithium batteries.
J Button to remove the batteries.
K Button to remove accessories / extension
tube.
L ON/OFF button.
M Speed selector button.
N Wall mounted and charging base.
O Power supply.
P EPA filter cover.
- If the model of your appliance does not have
the accessories described above, they can
also be bought separately from the Technical
Assistance Service.
USE AND CARE:
- Do not use the appliance without its filter(s)
correctly in place.
- Do not use the appliance if the accessories
attached to it are defective. Replace them
immediately.
- Do not use the appliance if the on/off switch
does not work.
- Respect the MAX level indicator.
- Remove the batteries from the appliance if you
are not going to use it for some time.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Keep the appliance in good condition. Check
that the moving parts are not misaligned or
jammed and make sure there are no broken
parts or anomalies that may prevent the
appliance from operating correctly.
- Do not work on areas where there are metal
objects, such as nails and/or screws.
- Never vacuum hot or sharp objects (cigarette
butts, ashes, nails, etc.).
- Do not open the battery/ies under any circum-
stances whatsoever.
- Recharge the battery/ies only with the charger
supplied by the manufacturer. A charger that
is suitable for one type of battery may cause
explosion or fire hazard when used with other
battery/ies.
- Use the device only with the battery/ies for
which has been specifically designed. The use
of any other battery/ies s can cause an explo-
sion or fire hazard.
INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
ASSEMBLING THE WALL BRACKET:
- The appliance has a charging base (N), which
must be fixed to the wall.
- Fix the wall bracket in the way you consider
most appropriate using plugs, screws, adhesi-
ves ...
- Drill into the marks and insert the dowels.
- Make sure that the support is anchored so that
it is capable of supporting at least twice the
weight of the appliance.
- Fit the appliance in its wall bracket.
CHARGING THE BATTERY
- Caution: A new battery is not fully charged and
must therefore be charged before the applian-
ce is used for the first time.
- Charge the battery at an atmospheric tempera-
ture of between 4 and 40ºC.
- A pilot light will come on to indicate that the
charger is ready to begin charging the battery.
- Approximately 4 to 5 hours are needed for a
complete charge of the battery. Never attempt