Working With The Device - ulsonix USX-ST2 Bedienungsanleitung

3.3.
1. Place the garment to be ironed on the hanger (not included).
2. Remove the water tank from the device, unscrew the cap and fill the tank
with clean, cold water. It is forbidden to pour hot water into the tank. Close
the cap and place the tank back in the device.
3. Connect the device to the power supply. Switch it on by setting the switch
I/O in position "I".
4. Use the steam output level button to set the preferred level (1-5). The
selected level will be highlighted on the display next to the I/O switch.
5. The device will begin to heat up and will be ready for use in approx. 60
seconds.
6. The device will emit an audible alarm when the water level is low. The alarm
switch off after the refilled water tank is replaced in the device.
7. It is not forbidden to fill the water tank when the device is switched on. To
refill the tank, switch off the device and let it cool down to avoid skin contact
with hot steam and heated parts.
8. To switch off the device, set the I/O switch to the "O" position and
disconnect from the power supply.
9. When you have finished working with the device and allowed it to cool down,
always empty the residual water from the tank to avoid limescale deposits.
INSTRUCTIONS FOR USE

Working with the device