Inhaltsverzeichnis
Werbung
KNX001 - Installation Manual
8
1. Safety Summary
Caution
This interface KNX001 must be installed by skilled personal
(electrician, EIB installer or other skilled technician).
Do not connect voltage input to the control system before
installation has been correctly completed.
Read this manual carefully before performing installation
work.
Read this manual in order to configure the KNX001.
Attention
Do not install KNX001 in places... :
outdoor.
−
with vapour, oil or dispersed liquids.
−
exposed to sun radiation.
−
with heat sources nearby (sulphuric surroundings).
−
where accumulation, generation or leaks of inflammable
−
gases has been detected.
that are near the sea, in saline, acid or alkaline
−
surroundings.
with wet environmment
−
2. Components names
2
1
Attention
Install KNX001 away from possible sources of
electromagnetic waves.
Respect local electrical standards.
Use a power circuit that is not subject to peak demands.
Ensure that there is enough free space around the KNX001
so that the heat may dissipate adequately
(refer to "Installation Work").
If you install the KNX001 in vertical position, install the power
supply in the lower part and the temperature control
outputs in the upper part.
3
4
Components supplied:
KNX001 device
−
1 console cable DB9 male - DB9 female (1,8 m length).
−
CD ROM: Software configuration, compatible with OS
−
Windows® and user manual.
Power adaptor: 12 V DC, 300 mA
−
Component names:
1. Power Supply Terminals
2. CSNET WEB Port
3. KNX TP-1 Port
4. PC-Console
PMML0137A rev0 - 06/2008
Werbung
Inhaltsverzeichnis
