Inhaltsverzeichnis
Werbung
KNX001 - Installation Manual
10
4.2 Installation process
1. Ensure that there is no power supply connected to any part of KNX001 (power terminals and EIB bus).
2. Install the device following the detailed explanations in 4.2.1 and 4.2.2. It is recommended to install KNX001 inside an
electrical box.
3. Connect current adaptor to the KNX001 keeping right polarity (see technical characteristics for power supply connections).
4. Connect CSNET WEB to KNX001 by ETH connector. CSNET WEB connection can be done directly by ethernet crossed
cable CAT5 or directly from LAN installation of the building. In the last case used non crossed ethernet CAT5 cable in order
to connect KNX001. Consult to computer net administrators for TCP connection. KNX001 is connected to CSNET WEB by
port 502.
5. Connect EIB bus to KNX TP1 (EIB) and keep correctly polarity.
6. Connect current adaptor to the power net.
7. Provide power to EIB bus.
8. Follow the instructions in TCXX0055_rev0 attached inside of CD ROM for KNX001 configuration and start up.
4.2.1
Wall Assembly
Pull the upper plastic parts and lower plastic part outside until fixing holes are visible from front side and a 'click' is heard (see right
figure below).
Back side view
Plastic parts positionated for rail DIN assembly
Use the holes of the plastic parts for wall mounting.
4.2.2
Rail DIN Assembly
Hang upper side of the device from the upper side of DIN profile. Using a screwdriver pull the lower plastic part (see drawing) and
push the lower side of the device against the profile.
Plastic parts ready for wall assembly
Side view
Front side view
PMML0137A rev0 - 06/2008
Werbung
Inhaltsverzeichnis
