Jog Mode - Julius Mayer JMHS-1 Originalmontageanleitung

Jog mode Enable/Disable)
1. Power is ON (motor is connected and ready for operation).
2. Press P2 programming key 1 x. Motor beeps 1 x.
3. Press UP key 1 x. Motor beeps 1 x.
4. Press P2 programming key 1 x. Motor beeps* 3 x.
5. OK! Jog mode activated / deactivated
*The frequency of the beeps or the reaction of the motor / shutter depends on the receiver.
Please refer to the corresponding instructions of the respective receiver / motor.
Delete handheld transmitter
1. Power is ON (motor is connected and ready for operation).
2. Press P2 programming key 1 x. Motor beeps 1 x.
3. Press STOP key 1 x. Motor beeps 1 x.
4. Press P2 programming key 1 x. Motor beeps 3 x*.
5. OK! ALL handheld transmitters are deleted!
*The frequency of the beeps or the reaction of the motor / shutter depends on the receiver.
Please refer to the corresponding instructions of the respective receiver / motor.
Individual deletion of hand-held or wall-mounted transmitters is NOT possible with the receivers!
For further information, please refer to the instructions of the Julius Mayer radio tubular motors or radio receivers.
PROGRAMMING
21