Programming; Programming Jmhs-1 - Julius Mayer JMHS-1 Originalmontageanleitung

PROGRAMMING

Programming mode - radio receiver or radio motor
Set the receiver (external Julius Mayer radio receiver or Julius Mayer radio motor) on which you want to program the
handheld transmitter is to be programmed, into programming mode according to the associated instructions.
Each keystroke must be executed within 4 seconds!
Otherwise, the system automatically exits the programming mode.
Programming the handheld transmitter - JMHS-1 (initial programming)
1. First set the receiver (motor/external receiver) to porgramming mode according to the instructions.
2. Press the P2 programming key (back) 2 x.
3. Press the UP key 1 x.
4. The motor (shutter) briefly moves UP/DOWN and/or the receiver beeps*.
OK! Programming successfully carried out!
5. To program additional receivers/motors, start from the beginning.
*The frequency of the beeps or the response of the motor/roller shutter depends on the receiver.
Please refer to the corresponding instructions for the respective receiver/motor..
Then check the function by pressing the UP/STOP/DOWN keys.
If the direction of rotation of the motor is reversed (roller shutter/motor moves downwards when the UP key is pressed),
please start from the beginning and press the DOWN key after the P2 key instead of the UP key!
This will change the direction of rotation of the motor.
To program several transmitters/channels for ONE motor/receiver, the „Add handheld transmitter" function must be used
(depending on the receiver model). Add handheld transmitter" function must be used (depending on the receiver model),
since - e.g. for radio motors - only one transmitter can be programmed directly into the receiver. Please observe the corres-
ponding instructions of the respective receiver/motor!
18
LED function display
Keys channel selection < > (not assigned at JMHS-1)
UP
Stop
DOWN
P2 key (programming key)