Add Handheld Transmitter - Julius Mayer JMHS-1 Originalmontageanleitung

PROGRAMMING
Add handheld transmitter (Ex: JMHS-15)
Set the receiver (external Julius Mayer radio receiver or Julius Mayer radio motor) on which you want to program the
handheld transmitter is to be programmed, into programming mode according to the associated instructions.
1. First select the desired channel by pressing the K1- or K2- key.
The selected channel is shown in the display (not applicable for JMHS-1).
2. On the new handheld transmitter to be programmed, select the channel to be programmed (not applicable to JMHS-1).
3. Press the P2 programming button (back) 2 times on the already programmed handheld transmitter.
4. Then press the P2 programming button (back) 1 x on the handheld transmitter to be reprogrammed.
5. The motor (shutter) briefly moves UP/DOWN and/or the receiver beeps*.
6. OK - Handheld transmitter is added!
*The frequency of the beeps or the response of the motor/roller shutter depends on the receiver.
Please refer to the corresponding instructions of the respective receiver/motor.
For further information, please refer to the instructions of the Julius Mayer radio tubular motors or radio receivers.
20
Key K1 (channel selection)
Key K2 (channel selection)
UP
Stop
DOWN
P2 key (programming key)