Main Technical Parameters; Using Method - Ufesa Scuti Bedienungsanleitung

- Do not use the appliance to dry clothes.
- Do not use the heater in the immediate surroundings of a bath, a shower or a swimming pool.
- Do not use the heater if it has been dropped:
- Do not use is the is a visible sign of damage to the heater.
- Use this heater on a horizontal and stable surface or fix it to the wall, as applicable.
- Always use the device in an upright position.
- Unplug the unit whenever not in use. Do not pull the cord to unplug the appliance.
- Do not use the device if it is cracked or broken.
- Do not use the appliance in rooms with a surface less than 4m2.
- The appliance has a security system to be disconnected in case of accidental overheating.
To keep the unit working again unplug the power for a few minutes, check that has no object
obstructing the air inlet, let the device cool down and plug it back.
- Improper use of the product may involve danger and revoke the warranty and liability
Do not use, connect or disconnect the device to the network with wet hands and/or feet.
- Do not wrap the cord around the control button.
- WARNING: Do not use this heater in small rooms when they are occupied by persons not
capable of leaving the room on their own, unless constant supervision is provided.
- WARNING: to reduce the risk of fire, keep textiles, curtains, or any other flammable ma-
terial a minimum distance of 1 m from the air outlet.
B&B TRENDS SL accepts no liability for any damage that may be caused to people, animals
or objects owing to failure to observe this warning correctly.

MAIN TECHNICAL PARAMETERS

Model Specification Voltage Frequency Rated power
Scuti Halogen tube 220-240 V 50/60 Hz 1200 W
CHASSIS FIXING
Note: install the chassis before use. (Only for those with chassis)
Method as such: remove the fastening screws (tightened when delivered from the factory) on
the base plate and thread the power cord through the center hole, and fix the chassis with the
body with removed fastening screws. Then give a tight press to the power cord and thread into
the trunk to lead out the cord.

USING METHOD

· Using method for mechanical type
1. The warmer is set with several shifts of power switch to enable users to choose for actual
demand.
2. Press the oscillating switch button, the warmer will work to oscillate within the scope of 90
degrees. (only for warmers with oscillating function)
3. The warming direction can be changed by slightly lifting the handle to rotate the frame, and
17