pizzato CS FS-5 Serie Bedienungsanleitung Seite 6

any application where the safety of two or more persons depend on the correct ope-
ration of the device.
b) Applications not contemplated in this instruction manual.
8 MARKINGS
The outside of the device is provided with external marking positioned in a visible
place. Marking includes:
- Producer trademark
- Product code
- Batch number and date of manufacture. Example: A22 CS1-123456. The batch's first
letter refers to the month of manufacture (A=January, B=February, etc.). The second
and third letters refer to the year of manufacture (22 = 2022, 23 = 2023, etc...).
9 TECHNICAL DATA
9.1 Housing
Material: Polyamide PA 66, self-extinguishing V0 acc. to UL 94
Protection degree:
Cable cross section:
Terminal tightening torque:
9.2 General data
SIL (SIL CL):
Performance Level (PL):
Safety category:
MTTF :
D
DC:
PFh :
D
Mission time:
Ambient temperature:
Storage temperature:
Mechanical endurance:
Electrical endurance:
Pollution degree:
Impulse withstand voltage U :
imp
Rated insulation voltage U :
i
Overvoltage category:
Air and surface distances:
9.3 Power supply
Rated supply voltage U :
n
Supply voltage tolerance:
Max. DC residual ripple:
Power consumption AC:
Power consumption DC:
9.4 Control circuit
Protection against short circuits:
PTC times:
Release time t :
A
Release time in absence
of power supply t :
R
9.5 Input circuit
Maximum resistance per input:
Current per input:
Response time t :
S
Min. duration of input signal t : > 100 ms
MIN
9.6 Output circuit
Output contacts:
Contact type:
Material of the contacts:
Maximum switching voltage:
Max. current per contact:
Conventional free air thermal current I
Max. total current Σ I
2 :
th
Minimum current:
Contact resistance:
External protection fuse:
Maximum switching load:
Utilization categories acc. to EN 60947-5-1:
AC-15 (50 ... 60 hz)
DC-13 (6 op. cycles/minute)
Utilization category acc. to UL 508:
Error signalling output Y14:
Rated operating voltage U :
e
Rated operating current U :
e
9.7 Compliance with standards
EN 60204-1, EN ISO 13855, EN ISO 14118, EN ISO 12100, EN ISO 13850,
EN 60529, EN 61000-6-2, EN 61000-6-3, EN 61326-1, EN 60664-1, EN 60947-1,
EN IEC 63000, EN ISO 13849-1, EN ISO 13849-2, EN 62061, UL 508, CSA C22.2
no. 14, GB/T14048.5-2017
9.8 Compliance with directives
Machinery Directive 2006/42/EC, EMC Directive 2014/30/EU, RohS Directive
2011/65/EU.
IP40 (housing), IP20 (terminal strip)
0.2 ... 2.5 mm (24 ... 12 AwG)
2
0.5 ... 0.6 Nm
Up to SIL CL 2 acc. to EN 62061
up to PL d acc. to EN ISO 13849-1:2015
Up to cat. 3 acc. to EN ISO 13849-1:2015
379 years
Medium
1,31 E-09
20 years
-25°C ... +55°C
-25°C ... +70°C
> 10 million operating cycles
> 100,000 operating cycles
external 3, internal 2
4 kV
250 V
II
acc. to EN 60947-1
24 V DC (terminals A1-A2)
120 V AC (terminals B1-B2)*
*
only for articles CS FS-5••120
±15% of U
n
10%
< 5 VA
< 2 w
PTC resistance, Ih = 0.5 A
Response time > 100 ms, release time > 3 s
See section OPERATION
< 100 ms
≤ 50 Ω
< 8 mA
< 150 ms
1 NO safety contact (17-18)
1 NC auxiliary contact (25-26)
1 CO auxiliary contact (35-36-38)
forcibly guided (17-18)
gold-plated silver alloy
230/240 Vac; 300 Vdc
6 A
: 6 A
th
36 A 2
10 mA
≤ 100 mΩ
4 A
1380 VA/w
U = 230 V, I = 3 A
e e
U = 24 V, I = 4 A
e e
C300
type: PNP
24 Vdc
10 mA
10 SPECIAL VERSIONS ON REQUEST
Special versions of the device are available on request.
These special versions may differ substantially from the indications in these operating
instructions.
The installer must ensure that he has received written information regarding the use
of the special version requested (see paragraph SUPPORT).
11 DISPOSAL
At the end of its service life, the product must be disposed of properly, according
to the rules in force in the country in which the disposal takes place.
12 SUPPORT
The device can be used for safeguarding people's physical safety, therefore in case of
any doubt concerning installation or operation methods, always contact our technical
support service:
Pizzato Elettrica Srl
Via Torino, 1 - 36063 Marostica (VI) - ITALY
Telephone +39.0424.470.930
E-mail tech@pizzato.com
www.pizzato.com
Our support service provides assistance in Italian and English.
13 EC CONFORMITY DECLARATION
I, the undersigned, as a representative of the following manufacturer:
Pizzato Elettrica Srl - Via Torino, 1 - 36063 Marostica (VI) – ITALY
hereby declare that the product is in conformity with whatever prescribed by the
2006/42/EC Machine Directive. The complete version of the present conformity
declaration is available on our website www.pizzato.com
Marco Pizzato
DISCLAIMER:
Subject to modifications without prior notice and errors excepted. The data given in this sheet are accurately
checked and refer to typical mass production values. The device descriptions and its applications, the
fields of application, the external control details, as well as information on installation and operation, are
provided to the best of our knowledge. This does not in any way mean that the characteristics described
may entail legal liabilities extending beyond the "General Terms of Sale", as stated in the Pizzato Elettrica
general catalogue. Customers/users are not absolved from the obligation to read and understand our
information and recommendations and pertinent technical standards, before using the products for their
own purposes. Taking into account the great variety of applications and possible connections of the device,
the examples and diagrams given in the present manual are to be considered as merely descriptive; the
user is deemed responsible for checking that the specific application of the device complies with current
standards. This document is a translation of the original instructions. In case of discrepancy between
the present sheet and the original copy, the Italian version shall prevail. All rights to the contents of this
publication are reserved in accordance with current legislation on the protection of intellectual property. The
reproduction, publication, distribution and modification, total or partial, of all or part of the original material
contained therein (including, but not limited to, texts, images, graphics), whether on paper or in electronic
form, are expressly prohibited without written permission from Pizzato Elettrica Srl.
All rights reserved. © 2022 Copyright Pizzato Elettrica
6/18