Technical Data - Meec tools 021737 Bedienungsanleitung

EN

TECHNICAL DATA

Voltage
Sawing speed
Size, blade
Saw width
Sound pressure level, LpA
Sound power level, LwA
Vibration level
Always wear ear protection!
The declared values for vibration and noise, which
have been measured according to a standardised
test method, can be used to compare different
tools with each other and for a preliminary
assessment of exposure. The measurement
values have been determined in accordance
with EN 60745-2-20:2009.
WARNING!
The actual vibration and noise level when
using tools may differ from the specified
maximum value, depending on how the
tool is used and the material. It is therefore
necessary to determine which safety
precautions are required to protect the user,
based on an estimate of exposure in actual
operating conditions (taking into account all
stages of the work cycle, e.g. the time when
the tool is switched off and when it is idling,
in addition to the start-up time).
DESCRIPTION
FIG. 1
FIG. 2
1. Tensioning arm
2. Speed control
3. Safety lock
4. Power switch
5. Guide plate
6. LED work light
30
18 V DC
174 m/min
835x13x0.5 mm
63.5 mm
75.5 dB(A), K=3 dB
86.5 dB(A), K=3 dB
does not exceed 2.5 m/s
7. Support handle
8. Blade cover
9. Lock for blade cover
ASSEMBLY
FITTING AND REPLACING BLADE
2
1. Turn the tensioning arm clockwise to
relieve the tension in the blade.
2. Centre the blade on the two head
bearings. Hold the blade on the head
bearings and press in. Check that the
blade runs smoothly round the wheels.
3. Turn the tensioning arm to tension the
blade.
4. Plug in the plug, put safety glasses and
ear protection, and start the product.
Check that the blade runs smoothly and
firmly round the wheels and that the
teeth point in the right direction.
FITTING THE GUIDE
1. Fit the guide before use.
2. Undo the screws on the bracket.
3. Put the guide round the blade and tighten
the screws.
USE
STARTING / STOPPING
1. Press the safety lock to release the power
switch, and start the product by pressing
the power switch.
2. Adjust the speed with the speed control.
Select a suitable speed for the material to
be sawn.
SAWING
WARNING!
• Keep the power cord away from the
work area.