NORDICCO NORTHERN AIR MINI Installationshandbuch Seite 12

The antenna must not be entangled with any wires and
*
covered in canopy.
*As shown in the figure, after wiring is completed, the
live wire (L), the neutral wire (N) and the earth wire (E)
should be at both sides of the Circuit Box Unit.
NORTHERN AIR ® MINI FAN Installation Manual
6
Use a wire connector to connect the
corresponding red/yellow/black wires both from
the circuit box unit and the motor.
- Install the safety cable to the yoke with bolt kit.
*Recommended Tightening Torque:
5 Nm. (50 Kgf.cm)
7
-Use a wire connector to connect wiring with
brown/blue wires of the circuit box unit, as well
as the earth wire of the yoke as shown.
-Please refer to ''Wiring Diagram'' later in the
manual.
•
Live wire: Brown (L)
•
Neutral wire: Blue (N)
•
Earth wire: Green Yellow (E)
8
- Loosen and use yoke bolt kit.
- Secure the circuit box unit's earth wire with the
yoke.
EN
10