Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
SAFETY INSTRUCTIONS
WARNING!
Read all warnings, safety instructions and
other instructions carefully before use.
Failure to follow all the instructions and
safety instructions can result in the risk of
electric shock, fire and/or serious personal
injury. Save these instructions and safety
instructions for future reference. The term
"power tool" in all the warnings below refers
to mains-powered (corded) or battery-
powered (cordless) power tools.
WORK AREA
•
Keep the work area clean and well lit.
Dark and cluttered work areas increase
the risk of accidents and injuries.
•
Do not use power tools in explosive
environments, such as in the vicinity of
flammable liquids, gas or dust. Power
tools produce sparks that can ignite dust
and fumes.
•
Keep onlookers, especially children, and
pets at a safe distance when using power
tools. You can easily lose control of the
product if you are distracted.
ELECTRICAL SAFETY
•
The plug on the power tool must match
the power point. Never modify the plug in
any way. Never use an adapter with
earthed products. Unmodified plugs and
matching power points reduce the risk of
electric shock.
•
Avoid body contact with earthed surfaces
such as pipes, radiators, cookers and
refrigerators. There is an increased risk of
electric shock if your body is earthed.
•
Do not expose power tools to rain or
moisture. There is a greater risk of electric
shock if water gets into a power tool.
22
•
Be careful with the power cord. Never use
the power cord to carry or pull the tool, or
to pull out the plug from the power point.
Keep the power cord away from heat, oil,
sharp edges and moving parts. Damaged
or tangled power cords increase the risk of
electric shock.
•
If using the power tool outdoors, only use
an extension cord approved for outdoor
use. Cords intended for outdoor use
reduce the risk of electric shock.
•
If it is absolutely necessary to use power
tools in damp conditions, use a mains
connection protected by a residual current
device (RDC). Using an RCD reduces the
risk of electric shock.
NOTE:
When starting the product there may be a
temporary voltage drop in the mains supply,
which could affect other equipment. Such
interference does not normally occur if the
impedance in the mains supply Zmax is less
than 0.402 ohm. Contact your electricity
supplier for more information.
PERSONAL SAFETY
•
Stay alert. Pay attention to what you are
doing, and use your common sense when
working with power tools. Never use
power tools if you are tired or under the
influence of drugs, alcohol or medication.
Remember that a fraction of a second of
inattention or negligence can result in
serious personal injury.
•
Use personal safety equipment. Wear
safety glasses. Depending on the type of
tool and how it is used, safety equipment
such as dust masks, non-slip safety shoes,
safety helmets and ear protection reduce
the risk of personal injury.
•
Avoid accidental starting. Make sure the
power switch is in the OFF position before
plugging in the plug or inserting the
battery, or lifting/carrying the tool.
Carrying a power tool with your finger on
the switch, or connecting a tool to the
Werbung
Inhaltsverzeichnis
