welltherm BP 550 Serie Installation Und Betriebsanleitung Seite 28

4
5
28
3 Check whether all
heater point with the opening in one direction. If not, align the V-
brackets uniformly in one direction. It does not matter in which direction.
4 Lift the heater to the mounting position so that the openings of the
V-brackets are directly in front of the screws already screwed in at a
distance.
5 Slide the heater sideways until the screws are fully inserted into the
V-holders. Pay attention to the correct position of the washers. These
must be located between the screw head and the V-holder.
6 Lock the heater by rotating the V-holders 180º:
Perform locking:
Rotate any V-holder 180º.
7 Tighten all 8 or 12 screws with the two wrenches 8 and 10 mm.
Check that the heater is fi rmly seated.
wall brackets (V-brackets) of your