Mount Heater - welltherm BP 550 Serie Installation Und Betriebsanleitung

3.5 - Mount heater

Recommended tool
Mounting template
Mounting
B
C
A
A Cordless screwdriver or electric drill
B Cutter knife or carpet knife
C Pencil or ballpoint pen
D Hammer
E Wrench with 8 mm width across fl ats (jaw or ring)
F Wrench with 10 mm width across fl ats (jaw or ring)
G Drill bit with 8 mm to match the material of your wall or ceiling
• Use the enclosed mounting template to determine the location of
the drill holes for mounting the product on the wall.
• Be sure to observe the requirements for the installation location and
the required minimum distances (see page 10).
• In general, we recommend using a spirit level for a plumb mounting
position.
1 First, drill the required holes with an 8 mm drill bit suitable for
the material of your wall at the previously marked positions.
Make sure that you do not drill into water or power lines.
- For heaters with 1,200 mm length, drill 4 holes.
- For heaters with 1,500 / 1,800 mm length, drill 6 holes.
The number of holes is also determined by the drilling template
supplied.
Please ensure correct positioning of the drill holes for optimum
mounting of the wall bracket (V-bracket) to be screwed to it
later.
2 Use (if suitable for the material of your wall) the supplied dowels,
the key screws and the washers from the „standard fi xing set"
supplied with the heater - as shown on the left. The wall mounting
material must be adapted to the wall condition on site if the
supplied material is not suitable!
Insert the dowels into the holes (hammer in with a hammer if
necessary) and screw in the screws with the washers using a
10 mm wrench. Do not tighten the screws completely. Leave 4 mm
space between the washer and the wall.
8 mm
E F
8 mm
G
D
10 mm
27