Nomestic N100 Handbuch Seite 5

Base Station (Receiver)
1
4
3
6
8
10
11
13
14
15
16
1. LCD Display (18cm diagonal)
2
2. Weather forecast
5
3. Remote sensor low battery
indicator
4. Light/Dimmer
7
5. Base station low battery
indicator
6. Outdoor temperature
9
7. Indoor temperature
8. Outdoor humidity
9. Indoor humidity
10. Barometric pressure with
history graph
12
11. °C/°F
12. Channel
13. History
17 14. Max/min
18
15. Battery compartment
16. DC power in
17. Mb/hPa barometric pressure
unit
18. Adjust weather
8 Buttons
• LIGHT/DIMMER: When
powered trough the adaptor, you can adjust
the brightness in three different levels. If it is
battery powered, the display will turn off after
15 seconds to save battery power. Press the
button to turn the display back on.
• HISTORY: Press this button to view the
barometric pressure history from the past 12
hours.
• °C/°F: Press this button to change temperature
units.
• inHg/mb: Press this button
barometric pressure units. mb is used
in Europe, which is the same as hPa or
hectopascal. inHg is used in the United States,
which means inches of mercury.
• MAX/MIN: Press this button once to show the
the display is maximum and minimum temperature and
humidity levels since the last reset. Press and
hold the button for three seconds to reset all
the min/max stored values.
• CHANNEL: Press once to view the different
temperature readings from up to three outdoor
remote sensors. If you press this button twice,
there will be a circular arrow
arrow is displayed, it automatically switches to
show the multiple outdoor sensors every five
seconds. Double press again to deactivate
automatic switching.
to change
• WEATHER: Press this button to select the
current weather conditions if you think the
predictions are not accurate. The device will
then re-learn through your inputs.
9
. If the circular