ENG
VACUUM CLEANER OPERATION
Use of attachment nozzles
1. The motorized floor brush is suitable for cleaning all kinds of surfaces: floors, carpets,
tiles, parquet, etc.
2. The brush nozzle allows you to effectively remove dirt from any surface.
3. Сrevice nozzle for cleaning in hard-to-reach places.
4. Mini power brush for furniture will effectively clean upholstered furniture.
Installing and removing the battery
Align the groove on the battery case and the
guide on the vacuum cleaner case and insert
it straight (as shown in figure) until it clicks.
Grasp the handle and press the battery
release button. While holding down the
button, remove the battery from the
instrument.
Connection and disconnection of the tube and body
By pressing the button on the body of the
device, you can disconnect the tube. To
connect the tube and the body, it is also
necessary to fix the rod in the desired
position until it clicks.
Connection and disconnection of the tube and the motorized floor brush
Lock the motorized brush to the tube until
it clicks into place. To remove the motorized
brush, press the button located on the shaft
and disconnect the attachment.
Removing and installing the dust tank
To detach and install the dust tank,
press the corresponding button and
turn the tank in the direction indicated
by the arrow.
Removing
the container
Turning on the appliance
Removable
battery
After pressing the power button, the
PowerTwin
device will start working.
When the button is pressed again, the
device stops working.
Push
Switch between three modes
Pressing the TURBO button sequentially
switches the operating modes of the
device:
When pressed, the corresponding speed
indicator lights up.
Operating mode
1. Eco mode
2. Basic mode
3. Turbo mode
Charging the battery
If the battery level indicator is at its
lowest and is blinking, the battery
needs to be charged.
Push
Installing
the container
Switching operating modes
Suction power
Battery life
12 000 Pа
up to 50 minutes
17 000 Pа
up to 25 minutes
24 000 Pа
up to 15 minutes
Battery level indication
(0-100%)
Power switch
Operating mode indication
Operating mode selection button