To Tune In A Preset Station - Aiwa CDC-MP3R YZ Bedienungsanleitung

PRESETTING STATIONS
To preset stations manually
You can manually preset stations that have not
been selected by an auto memory operation.
1
Press FUNCTION repeatedly to select
the band from among F1 (FM1), F2
(FM2), F3 (FM3), MW and LW.
2
Tune in the station that you wish to
preset with TUNE i or TUNE k.
3
Press and hold one of the preset station
buttons 1 to 6 for approximately 2
seconds.
While the station you are presetting is being
registered in memory, the unit beeps.
The preset station number appears to the
right of the frequency indication.
Preset station number
Repeat these procedures to preset up to 6 stations
each for F1, F2, F3, MW and LW.
• If you preset a station on a preset station button
on which another station of the same band has
already been preset, the previously preset station
will be erased.
7
ENGLISH

To tune in a preset station

1
Press FUNCTION repeatedly to select a
desired band from among F1 (FM1), F2
(FM2), F3 (FM3), MW and LW.
2
Press the desired preset station button.
The preset station number appears to the
right of the frequency indication.
Active tuning reception control (ATRC)
This unit automatically suppresses FM noise
caused by varying signal strength resulting from
movement of the car.
• The built-in automatic blending circuit mixes the
left and right channel signals according to the
strength of the reception. At the same time, the
high-cut circuit activates to maintain sound
quality.
• If the reception becomes even weaker, the unit
automatically switches to Monaural mode to
reduce noise.
tousi-E-8