Disposal Instructions - Goobay 53999 Betriebsanleitung

5 V - 15 V Universal Power Supply
EN
Alimentation universelle 5 V - 15 V
FR
Voltage-free only with pulled plug.
• In case of emergency, during thunderstorms and after use,
pull the product on its plug housing! In case of emergen-
cy, during thunderstorms and after use, pull the product on
its plug housing!
• Do not open the housing.
• Do not modify product and accessories.
• Do not short-circuit connectors and circuits.
A defective device may not be put into operation, but must be
disconnected from mains and protected against further use.
• Use product, product parts and accessories only in per-
fect condition.
• Avoid stresses such as heat and cold, moisture and direct
sunlight, microwaves, vibrations and mechanical pressure.
• In case of questions, defects, mechanical damage, trouble
and other problems, non-recoverable by the documentati-
on, contact your dealer or producer.
• Do not repair defective products yourself, but contact the
dealer or the manufacturer.
Not meant for children. The product is not a toy!
• Secure packaging, small parts and insulation against ac-
cidental use.
Tripping hazard
Cables can be overlooked.
• Route the cable safely.
• Install the product and devices attached to it in a way that
persons cannot be injured, or objects cannot be damaged
for example by dropping or stumbling.
Heat accumulation
• Do not cover the product.
• Keep enough space around all devices for a good ventlati-
on and free motion and to avoid damages.
2 Description and function
2.1 Product
The product is a universal power supply unit for charging and
operating office equipment via a DC connection. It has inter-
changeable adapter plugs for many common devices. The
output voltage can be variably adjusted.
2.2 Scope of delivery
5 V - 15 V Universal Power Supply, 8 adapter plugs, adjust-
ment tool, User Manual
2.3 Operating Elements
See Fig. 1.
1 Operating LED
2 DC socket
3 Euro plug
4 Adjustment tool
3 Intended use
We do not permit using the device in other ways like
described in chapter „Description and Function" or in
the „Safety Instructions". Use the product only in dry
interior rooms. Not attending to these regulations and safety
instructions might cause fatal accidents, injuries, and dama-
ges to persons and property.
4 Preparation
1. Check the scope of delivery for completeness and in-
tegrity.
2. Compare the specifications of product, power supply and
peripherals.
These must be identical.
5 Connection and operation
NOTICE! Material damage due to incorrect output
voltage or polarity
If the output voltage is too high or the polarity is incorrect, your
connected device may be severely damaged. Information on
polarity and voltage can be found in the operating instructions
of your device or on the original power supply unit.
• Do not overload the product.
• Make sure that the polarity is correct.
• Do not operate your equipment until the correct output vol-
tage has been set.
1. Determine the required output voltage for your device.
2. Turn the switch for setting the output voltage (6) with the
aid of the setting tool (4) so that the arrowhead points to
the required output voltage.
REV2022-08-26 Subject to change without notice. |
V3.2aw Sous réserve de modifications.
5 Adapter plugs
6 Switch for setting the out-
put voltage
3. Connect the appropriate adapter
plug to the DC socket (2) of the
power supply unit. Pay attention
to the correct polarity (see image
on the right) and fit of the plug.
Most devices work with positive polarity, i.e. with the positi-
ve pole on the inner contact.
4. Connect the adapter plug to the unit.
5. Insert the Euro plug (3) into a free and easily accessi-
ble socket.
The operating LED (1) lights up while the power supply
unit is connected to a power supply.
6. Disconnect all plug connections after use.
6 Maintenance, Care, Storage and Transpor-
tation
The product is maintenance-free.
NOTICE!
• Always disconnect the mains plug before cleaning.
• Only use a dry and soft cloth for cleaning.
• Do not use detergents or chemicals.
• Store the product out the reach of children and in a dry
and dust-protected ambience when not in use.
• Store cool and dry.
• Keep and use the original packaging for transport.

7 Disposal instructions

According to the European WEEE directive, electrical
and electronic equipment must not be disposed with
consumers waste. Its components must be recycled or
disposed apart from each other. Otherwise contamina-
tive and hazardous substances can damage the health and
pollute the environment.
As a consumer, you are committed by law to dispose electrical
and electronic devices to the producer, the dealer, or public
collecting points at the end of the devices lifetime for free.
Particulars are regulated in national right. The symbol on the
product, in the user manual, or at the packaging alludes to
these terms. With this kind of waste separation, application,
and waste disposal of used devices you achieve an important
share to environmental protection.
WEEE No: 82898622
1 Consignes de sécurité
Le mode d'emploi fait partie intégrante du produit et comprend
d'importantes informations pour une bonne installation et une
bonne utilisation.
• Lisez le mode d'emploi attentivement et complètement
avant de l'utiliser.
Le mode d'emploi doit être disponible à des incertitudes et
transfert du produit.
• Conservez soigneusement ce mode d'emploi.
Notes pour la séparation des réseaux
Le produit n'a pas d'interrupteur d'alimentation et peut être uti-
lisé que dans des points facilement accessibles en cas d'ur-
gence et rapidement après l'utilisation de cette pour les sup-
primer.
Sans surcharge de tension uniquement lorsque le bouchon
est tiré.
• Tirez en cas d'urgence directement après utilisation et
pendant les orages, branchez le boîtier de connecteur!
• Ne pas ouvrir le boîtier.
• Ne modifiez pas le produit et les accessoires.
• Pas court-circuiter des connexions et circuits.
Un appareil défectueux ne doit pas être mis en service. Il doit
au contraire être immédiatement mis hors tension et protégé
contre toute utilisation involontaire.
• Utilisez le produit, pièces et accessoires des produits uni-
quement en parfait état.
• Éviter des conditions extrêmes, telles que la chaleur ex-
trême et froid, l'humidité et de la lumière directe du so-
leil, ainsi que microondes, des vibrations et de la pressi-
on mécanique.
• En cas de questions, les défauts, les dommages mécani-
ques, des ingérences et d'autres problèmes, non récupé-
rables par la documentation, contactez votre revendeur ou
le producteur.
• Ne réparez pas vous-même les produits défectueux, mais
- 3 -
Pillmannstraße 12 | 38112 Braunschweig | Germany
53999
Material damage
Goobay® by Wentronic GmbH