Inhaltsverzeichnis
Werbung
8.2 English
If the item does not work properly:
Error „rES" only models with display):
Error "Er10"---"Er60" only models with display):
Error "HOT" only models with display):
Error E60 (only models with display):
In general:
Hight during reset:
Set collision protection:
35 - 38 / Mendler Vertriebs-GmbH, Industriestr. 60, D-73642 Welzheim / XD04-3-2T / Höhenverstellbarer Schreibtisch 3 in 1 D40 / 20.07.2022
A reset may be necessary. Pull out the mains plug for 20 seconds and then carry out the reset as described under point 11.
Please carry out the reset as described under point 11.
Make sure all cables are properly connected to the control box. Then carry out the reset as described under point 11.
Let the base cool down for 20 minutes
E60 means out of step, the height of two or three legs is inconsistent. Under normal circumstances, the reset operation can solve
this problem. The operation is asfollows:
1. First, please confirm that all data cableplugs and sockets are connected normally.
2. Long press the "down" key, the LED will display "res", the table will start to fall to the lowest level and rebound to rise, at this time,
the LED will display the lowest height number "62.3", and finish.
If it still doesn't work, the reason may be that the data transmission is blocked. It may be necessary to replace the motor or data
cable, or the control box.
If the error message persists after the reset procedure, contact your seller.
If the height between the legs exceeds 1.5 inches, stop the reset procedure&contact your seller.
Please doing as below:
1. Press "M" 3 seconds, handle shows"---"
2. Press "M" again.
3. Press the "UP" or "DOWN" key choose the "CF", then press "M".
4. Now you can press the "UP" or "DOWN" key choose the options you need:
OFF: Off, close the collision protection.
L: Light
N: Normal
H: Heavy
Yes, the table will stop if there is anything under the table like a shelf or anything like this.
Werbung
Inhaltsverzeichnis
