Supra ORSO 1500 Gebrauchsanleitung Seite 7

USE
Extend the cable completely before plugging
it in.
Take the length of cable required out of the
housing.
Connect the appliance to the mains.
Turn the appliance on, by using the on/off
switch.
Turn the appliance on, by using the on/off
knob.
The pilot light (A) comes on.
Select the desired power.
Turn the thermostat control to the desired
temperature position.
During the appliance's use the pilot light (A) will
come on and off automatically, indicating the
heating elements are working, and therefore
maintaining the desired temperature.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE
Select the minimum position (MIN) using the
thermostat control.
Turn the appliance off, using the on/off switch.
Unplug the appliance from the mains.
Put the cable back in the cable housing.
The cable housing means you can remove and
have available the required length of cable for
working with the appliance, preventing accident
risk situations.
Clean the appliance.
CABLE COMPARTMENT
This appliance has a cable compartment
situated on its underside. (D).
CARRY HANDLES
This appliance has a handle on the side of the
body, which facilitates comfortable transport.
(E).
ANTI-TIPPING SAFETY DEVICE
The appliance has an anti-tipping safety device
that turns it off if the working position is not the
correct one.
SAFETY THERMAL PROTECTOR
The appliance has a safety device, which
protects the appliance from overheating.
If the appliance turns itself off and does not
switch itself on again, disconnect it from the
mains supply, and wait for approximately 15
minutes before reconnecting. If the machine
does not start again seek authorised technical
assistance.
CLEANING
Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an
acid or base pH such as bleach, or abrasive
products, for cleaning the appliance.
Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
Never submerge the appliance in water or any
other liquid or place it under running water.
If the appliance is not in good condition of
cleanliness, its surface may degrade and
inexorably affect the duration of the appliance's
useful life and could become unsafe to use.
Remark: When the appliance is used as a
heater after long periods in storage or after
having been used solely as a fan a small
amount of smoke may be produced. This is
not important and is due to the heater burning
dust deposits which have accumulated on the
heating element. This phenomenon may be
avoided by cleaning the inside of the appliance
beforehand through the grill with a vacuum
cleaner or pressurised air.