GARDY SHELTER PLUS Aufbauanleitung Seite 39

Fit 2 walls, front and back (part K), in the cutouts placed on the upper side boards.
The length and height may have deviation of ±5mm. Fit 5 purlins, a ridge purlin and 4
intermediate purlins (parts G and G1).
ATTENTION! Each purlin has been designed to fit perfectly to the walls.

Check the inclination of each purlin to ensure it's in correct position.
Reinforce the construction with 4 ridge battens (part S) fixed from the inside to the front and
back wall using M8x60 screws. These parts should be screwed after tightening the side,
front and back walls of the garden house.
NOTE:
4 The ridge battens should be screwed only to the lower board at the very bottom and to
the first board at the top;
4 M8x60 screws shouldn't be over tightened to give the boards ability to work.
⑦
DOOR ASSEMBLY
CODES PART DESIGNATION
I Right door and left door (partially glazed)
Place the two doors (part I) on the hinges.
I
I
I2
I
I
I1
I3
DIMENSIONS (MM)
700 x 1850 mm
GB
I1
QTY
2
39