Getting Started; Deairing The Machine - Sjöstrand BRASS Bedienungsanleitung

GETTING STARTED

· lnsert the power socket into a power outlet.
· Fill water tank with cold water.
· Place the drip tray in the appropriate height for your cup size.
It is possible to detach the drip tray and lay it flat at the bottom surface underneath
the nozzle for larger cups or macchiato glasses.
· Switch the machine ON by flipping the toggle switch up.
Both cup size buttons will start blinking to indicate that the machine is warming up.
The machine is ready to use when the lights stops blinking and stays on.
· Run 4-6 cups of water before your first brew.
· Drop a coffee capsule in the capsule inlet on top and pull the capsule lever inlet
down.
· Press the small cup button for an expresso (40 ml).
· Press the large cup button for a lungo (100 ml).
· Lift the capsule inlet lever up each and every time a brew is complete to make the
used capsule drop down into the capsule container.
!
It is not recommended to fill the water tank with hot water. Keep in mind the Max/
Min volume levels.

DEAIRING THE MACHINE

When your new machine arrives, it would have been completely drained of water and you
will need to deair it. You will notice this when you have filled the water tank, but no water
comes out when it's supposed to start brewing. The machine will also make the same
noise it does when performing a normal brewing procedure.
To run water through the machine, follow the steps below:
· Turn on the machine.
· Fill up the water tank.
· Have the capsule inlet lever in its upright position. Push it slightly further back
towards the back of the machine until you hear a sound.
· Run a cup of water through the machine before brewing a cup of coffee by pressing
either the small cup or the large cup button. Your machine is deaired when water
comes out of the nozzle.
6