Jeep Adventurer Bedienungsanleitung Seite 9

Sentinel:
• Open the package and remove the upper packaging materials.
• Open the handlebar stem and secure it by folding the lever on the locking mechanism.
• Connect the display power cable to the main wiring (if necessary).
• Install the handlebar on the steering wheel taking care to the wires and insert the 4 screws, tighten them using the hex
wrench.
• Take the item out of the packaging
• Open the kickstand and check that the item is stable
• Adjust the steering wheel closing mechanism (if needed)**.
Model Reference picture
Adventurer
Urban
Camou
Sentinel
CAUTION
Assemble the item correctly. If, during assembly, any factory defects are detected, certain steps are unclear or issues
with assembly or adjustments occur, do not ride the vehicle and contact your dealer or visit www.urbanchicemobility.it for
technical support.
Do not use accessories and/or additional parts that are not approved by the manufacturer.
Keep children away from plastic items (including packaging materials) and small parts that may result in suffocation.
It is forbidden to modify or transform the item or any its parts in any way, as this may impair efficiency, reduce structural
integrity and cause damage. Remove any sharp edges caused by misuse, breakage or damage to the item. If any factory
defects, unusual noises or faults are detected, do not ride the vehicle and contact your dealer or visit
www.jeepurbanemobility.com for technical support.
* Adjustment
Outside the mechanism there is a hex socket screw. If the han-
dlebar stem is not very stable after closing, adjust the screw
in the mechanism, by tightening or loosening it as required to
increase the stability of the stem.
Inside the closing mechanism lever there is a hex wrench. If the
handlebar stem is not very stable after closing, adjust the screw
in the mechanism, by tightening or loosening it as required to
increase the stability of the stem.
08