Preliminary Measures Prior To Charging; Operation Instruction - ChargeXpert ECO-PC001-16 Bedienungsanleitung

PRELIMINARY MEASURES PRIOR TO CHARGING

Before using this cable to charge your vehicle, please follow the steps below to ensure safe use of the
product.
Ensure the charging cable is free from damage, rust and any other abnormality. If it has
▪
damage, rust or any other abnormality, please do not use it.
Check to see if the cable has any moisture. If so, please wipe dry with a clean & dry cloth
▪
and allow it to fully dry.
▪ Make sure you have the correct cable for your vehicle.
Never use the cable in an environment where there is flammable substances.
▪

OPERATION INSTRUCTION

To use the electric vehicle cable, please follow the instructions below:
1.
2.
3.
4.
5.
6.
7.
Before using the cable, please refer to your vehicle manual and
familiarize yourself with instructions on how to charge your
vehicle.
Completely unroll the charging cable to avoid heat build-up and
tripping.
Plug the cable into your mains power supply. You should see the Power LED
(Green), Charging LED (Green) and Fault LED (Red) on the control box
flashing simultaneously which indicates that the control box is performing a
self-check.
Once the self-check has been completed, you will only see the Power LED
come on to inform you that it is idle and ready for charge.
Insert the other end of the cable into the inlet socket of your
vehicle. Once connected, the Charging LED on the control will begin
to flash to indicate that the charging is in progress.
Once the charging is complete, the display box will show both the
Power LED and the Charging LED as fully lit.
To stop charging, turn off the main power supply, and then
disconnect the plug from the vehicle inlet. Remove the power plug
from the socket.