Technical Data - Profi Air 1260250 Bedienungsanleitung

Congratulations! With the PROFIAIR cable roller you've opted for modern technology and simple
operation. Please pay careful attention to our directions regarding connection, operation and
maintenance. This will ensure safe functioning and a long service life.

1. TECHNICAL DATA

Article number: 1260250
Cable length: 20 m
Maximum load capacity in the rolled up state: 1000 Watt
Maximum load capacity in the unrolled state: 2300 Watt
Voltage: 400 V 3N ~ 50 Hz
Power cable: H07RN-F 5x1,5 mm²
Net weight: 8,5 kg
AHS GmbH, Uhlandstraße 50, A-4600 Wels
2. MATERIALS
We have constructed your PROFIAIR cable roller from selected materials:
• housing made of impact-resistant plastic
• spring made of high-quality spring steel
• flexible, temperature-resistant neoprene rubber according to H07RN-F standard
3. WALL MOUNTING
IMPORTANT: follow assembly instructions closely!
Mount the PROFIAIR cable roller:
• with 2 screws Ø10 mm
• on a sufficiently strong wall or ceiling
• at least 1.5 m above the floor
4. CONNECTION
The input supply voltage of the PROFIAIR cable roller may not exceed the maximum permissible
value. The energy consumption of connected devices must remain within the permissible values. The
corresponding data can be found on the outside of the housing.
Only use the cable roller dry areas that correspond to the official guidelines for electronic devices.
Installation and maintenance may only be carried out by qualified professionals.
ATTENTION! The manufacturer assumes no liability for damages or injuries resulting from improper
installation or handling of the cable roller.
Voltage display:
This cable roller is equipped with a mains display. When the cable roller is plugged into an outlet, the
red LED on the side lights up.
5. HANDLING:
The cable roller is equipped with an automatic stop mechanism.
Unrolling: pull the cable out to the desired length. Now slowly pull the cable out a bit further (up to
approx. 30 cm) until you hear a "clicking" sound.
Now the cable roller has locked into place and you can let go of the cable.
Rolling in: pull the cable out further (up to approx. 30 cm) until you don't hear a "clicking" sound any
more. Now let the cable out a little further and the cable will be pulled in automatically.
1260250_BDA_Kabelaufroller.indd 5 1260250_BDA_Kabelaufroller.indd 5
GB
PROFIAIR CABLE ROLLER
OPERATING MANUAL
18.11.21 10:32 18.11.21 10:32