Before Use; Boiling Water - Zelmer ZCK8026 Benutzerhandbuch

PL EN
Do not put the jug on a stove or in a microwave for re-heating of water.
Always place the kettle on a stable, smooth, flat surface; the power cord must not hang loosely off the
edge of a table (or any other work surface) or touch a heated surface.
Do not use the kettle with the lid open.
Do not remove the lid when the water is boiling.
If the internal electrical elements are flooded with water, make sure the kettle is completely dry before
plugging in.
Do not move while the kettle is switched on.
Unplug the product immediately from the mains in the event of any breakdown or damage and contact
an official technical support service. In order to prevent any risk of danger, do not open the device.
Only qualified technical personnel from the brand´s Official technical support service may carry out
repairs or procedures on the device.
B&B TRENDS S.L. disclaims all liability for damages that may occur to people, animals or objects, for
the non-observance of these warnings.
INSTRUCTIONS FOR USE

Before use

Make sure that all the product's packaging has been removed.
Before heating water for the first time, we recommend using the kettle twice, in order to clean it properly.

Boiling water

Open the lid.
Fill the kettle with fresh water to the desired level.
Do not fill less than the minimum and more than maximum marks indicated.
Close the lid and place the kettle onto its base.
Plug the appliance to the mains and the buzzer will beep twice.
Press the on/off button, you will hear a beep and the appliance will start working (it will automatically boil
until 100ºC).
After the water boils, and you will hear 2 beeps
The working indicator light orderly turns to the colors corresponding to the temperatures 100 ºC - 50 ºC -
70 ºC- 80ºC-90ºC and so on.
There are 5 temperatures 50/70/80/90/100ºC for selecting. Press the button. The kettle will start the
100ºC boiling mode.
The buzzer beeps 1 time and the working indicator light turns to red. The kettle starts boiling until 100 ºC
and then the buzzer beeps twice. The working indicator light will be off.
Select the desired temperature by pressing the button +/- . The temperature button indicator light turns to
blue. The blue temperature button indicator light turns off if no operation in 1 minute.
Once the temperature is selected, press the button to start boiling. The working
indicator light will turn to the colors corresponding to the temperatures 50/70/80/90 ºC.
The buzzer will beep 1 time every pressing buttons. When the kettle reaches the selected temperature,
the buzzer beeps 2 times. The working indicator light turns off. The blue temperature button indicator
light turns off if no operation in 1 minute.
10