Circuit Diagram - Metro GPP1005 Gebrauchsanweisung

Problem Possible cause
Emergency
switch not reset.
Appliance
Overcurrent
does not protection switch not
operate.
reset.
The upper lid
/ outlet lid is
open and the
micro-switch was
activated.
Peeling plate
not properly
installed.
Peeling chamber
overloaded.
Appliance is
very noisy.
Appliance not in
a stable position.
Peeling
plate does Wires in the plug
not rotate in not correctly
anti-clockwise installed.
direction.
Water tap not
opened.
Water inlet
hose blocked or
damaged.
No water
let into the
peeling
chamber.
Water control
valve is blocked
or damaged.
Solution
Rotate the
emergency switch
clockwise until it
pops out to the
initial position.
Press the overcurrent
protection switch to reset it.
Close and lock the
upper lid / outlet lid
properly.
Empty the peeling
chamber and re-
install the peeling
plate correctly.
Reduce the amount
of the potatoes
in the peeling
chamber.
Place the appliance
in a stable position.
Ensure the two feet
are firmly secured
on the ground
with the provided
mounting sets.
Have the wire
installation of
the 3-phase-wire
plug checked and
exchanged by a
qualified specialist.
Open the water tap.
Remove the
blockages with
suitable tools, or
replace the hose
with a suitable new
one recommended
by the manufacturer
or its service agent.
Remove the
blockages with
suitable tools, or
have the valve
replaced by the
manufacturer, its
service agent or
similarly qualified
persons.
- 16 -
Problem Possible cause
Too little or Water control
much water valve not
in the peeling properly
chamber. adjusted.
Blockage in the
appliance.
Appliance
stops
suddenly.
Other electrical
defect.
Pulse button not
Outlet lid
pressed.
opened,
but peeled
Peeling plate
potatoes not
blocked.
discharged.
6. Circuit diagram
For the circuit diagram, please see illustration at the
end of this manual.
a. Power input
b. Circuit breaker
c. Indicator (white)
d. Emergency switch
e. Micro-switch (upper lid)
f. Micro-switch (outlet lid)
g. Indicator (green)
h. Pulse button
i. Timer
j. Contactor
k. Black
l. Red
m. Blue
n. Operating capacitor
o. Power capacitor
p. White
q. Centrifugal switch
Solution
Check and adjust
the water control
valve.
GB
Press the
emergency switch
and disconnect
the appliance
from the power
supply; remove
the blockage with
proper tools and
clean the appliance
thoroughly.
Have the appliance
checked by the
manufacturer, its
service agent or
similarly qualified
persons.
Press the pulse
button.
Empty the
peeling chamber
and remove the
blockages.