Programming Tracks And Files; Procedure With Audio Cd; Procedure With Audio Files - Kenwood M-822DAB Bedienungsanleitung

Play tracks briefly: Press and hold the <INTRO> button on the remote control to play the tracks for 10
seconds. Pressing again stops the mode.

Programming tracks and files

Using the remote control, you can programme tracks from an audio CD or files to play in the order
you desire. The following number of spaces in memory is available to you for this:
Audio-CD:

Procedure with audio CD

1. The "CD" source must be in Stop mode, otherwise "STOP FIRST" will show in the display.
2. Press the <PROG> button to start the programming mode.
3. The display will now show "P01 001" where "01" will be shown. The first block of numbers
shows the current track, the second block of numbers shows the current storage space.
4. Using only the <TRACK SKIP FORWARD> or <TRACK SKIP BACKWARD> button, select the track
which you want to drop into the current storage space.
5. Press the <PROG> button to confirm the operation.
6. Afterwards the next storage space will be displayed. Repeat steps 4 and 5 until your selection is com-
pleted or the complete number of memory spaces in occupied. In this case, "Full" will be displayed.
7. With the <PLAY/PAUSE> button, you can start playback of the programmed tracks. During
playback the number of the track and that of the programme space will be alternately displayed.
8. Pressing the <STOP> button twice deletes the programming.

Procedure with audio files

1. The "USB" source must be in Stop mode, otherwise "STOP FIRST" will show in the display.
2. Press the <PROG> button to start the programming mode.
3. The display will now show "P01 001" where "01" will be shown. The first block of numbers
shows the current track, the second block of numbers shows the current storage space.
4. Using only the <TRACK SKIP FORWARD> or <TRACK SKIP BACKWARD> button, select the track
which you want to drop into the current storage space.
5. Press the <PROG> button to confirm the operation.
6. Afterwards the next storage space will be displayed. Repeat steps 4 and 5 until your selection is com-
pleted or the complete number of memory spaces in occupied. In this case, "FULL" will be displayed.
7. With the <PLAY/PAUSE> button, you can start playback of the programmed tracks.
8. Pressing the <STOP> button twice deletes the programming.
• If the <STOP> button is pressed during programming the process is interrupted. Turning off
the device deletes any programme which is present.
20 memory spaces Files: 99 memory spaces
11