Moni ABBA Gebrauchsanleitung Seite 13

•
Keep the plastic bag away from children to avoid the risk of suffocation.
•
Do not allow children to play around the product while there is another child in it.
•
Do not attach to the product or give the child any other items or accessories that are not provided by the
manufacturer.
•
Store away from children.
•
Use the highest position of the backrest only when the child is stable enough and does not lean.
INSTRUCTIONS AND WARNINGS FOR WORKING WITH BATTERIES - illustration B
Find the battery
alkaline batteries (not included), observing the polarity marked on the bottom of the compartment. Put the battery
cover back on and tighten the screws with a screwdriver. Do not overtighten.
To remove the batteries, repeat the steps.
Note: Restart the electronics if the mechanism becomes unstable. Turn off the power button, remove the
batteries, and then insert them following the steps above.
IMPORTANT! The batteries are exhausted if the movement and volume of the music weaken. Replace them
with new ones and dispose of used batteries in the designated area.
WARNING!
•
Only an adult should handle the batteries.
•
Always use new batteries.
•
If you are not going to use the product for a long time, remove the batteries.
•
Remove used batteries from the product and dispose of them in the designated areas, not in household waste
containers.
•
Do not dispose of batteries in a fire as there is a risk of explosion or leakage.
•
Non-rechargeable batteries are not to be recharged.
•
Use only the type of battery recommended by the manufacturer.
•
Different types of batteries are not to be mixed.
•
New and used batteries are not to be mixed.
•
Batteries are to be inserted with the correct polarity.
IMPORTANT! The diagrams and figures in this instruction are illustrative and indicative only.
Follow exactly the instructions and sequence for assembling and operating with the product.
Check the securing of the fixation after each operation.
Fixing a certain position in most cases is accompanied by a clicking sound.
Components - illustration A
After unpacking, make sure that all elements of illustration A are available.
Assembling the base - illustration C
Insert items 4 and 5 into items 22 and 23. Pull button 2 and at the same time lift up button 1 to open the stand.
Pull the plates of elements 12 and 13 as illustrated. Connect element 6 and element 9 and place elements 12 and 13
on element 9. Insert and tighten 4 screws A.
WARNING! Make sure that the base is assembled correctly and is stable, this ensures the safety of your child!
Assembly of the structure - illustration D
Place elements 17, 18, 19 and 20 on element 16. Fix element 1 on them. Carefully pierce pipes 14 and 15 through part
1 and fix for elements 12 and 13. Insert and tighten 4 screws B.
Turn the structure over and fix the supports - 7, 8, 10 and 11.
Do not use element 21 in an upright position, but only in a horizontal position on the backrest.
Placing the toy bar – illustration Е
Fix the toy bar - part 2, for element 12.
Inserting a music mechanism - illustration F
Fix element 3 to pipe 14.
Press the on / off button to activate the mechanism. With the upper button you can play music, and with the lower
one - you can activate the vibration.
cover. Use a screwdriver to loosen the cap screws. Take it off. Insert 2 1.5 V type AA (LR6)
ASSEMBLY INSTRUCTIONS
OPERATING INSTRUCTIONS
13