ATOMSTACK A5 Pro Laser Installationsanleitung Seite 7

1
Y
3
3
S t e p 2
2
X
1
3
Control box *1
The guide rail passes through
the middle of the 3 rollers.
Loosen the distance between
the upper and lower guide
wheels appropriately.
Step2 Required
components:
M5 screws*8
X-axis components*1
Installation Manual:
1.Push the X-axis component into the base
frame in the direction shown in the figure. Adjust
the eccentric nut appropriately.
2.Install the control box as shown.
3. Use an M5 Allen key to install 3 Support
gasket.
Support gasket
*3