Mounting Method; Technical Data - Olymp GOsafe 50A Bedienungsanleitung

Setting the user code
• With the door open, press the reset button.
• When the yellow light turns on, start setting the code.
• Enter the new code (3-8 digits).
• Press the "A" or "B" button.
• Acceptance and storage of the new code is confirmed with 2 beeps.
• If the yellow light flashes and 3 signal tones sound, the code change is not effective and it must be tried again.
Alarm - Wrong code
• If 3 consecutive incorrect entries are made, the warning tone sounds for 20 seconds.
• If another 3 consecutive incorrect entries are made, the warning tone will sound for 5 minutes.
CAUTION: The keypad is disabled during the beep. You can only stop the beeps by opening the safe with the
emergency key and disconnecting the power supply by removing the battery.

Mounting method

Mount the safe in a place that is not easy to move.

Drill the holes for the expansion screws (or clamping screws) in the right place.

Turn the expansion screws anticlockwise to loosen them.

Use the expansion screws (or the clamping screws) to fix the cabinet to the wall.

Make sure the enclosure is fixed in the right place, then tighten all the screws.
CAUTION: Use the expansion screws if there is a concrete wall. Use the clamping screws if there is a wooden wall.

Technical data

Dimensions (H × W × D)
GOsafe 50A
GOsafe 50B
GOsafe 50C
GOsafe 50D
Weight
GOsafe 50A
GOsafe 50B
GOsafe 50C
GOsafe 50D
Lock variant
Door thickness
Wall thickness
Batteries
Warranty
Dear customer,
We are delighted that you have chosen this equipment.
In the case of a defect, please return the device together with the receipt and original packing material to the point
of sale.
Outside: 360 × 300 × 100 mm
Outside: 450 × 360 × 120 mm
Outside: 650 × 420 × 120 mm
Outside: 756 × 584 × 330 mm
7 kg
11,5 kg
18,5 kg
64 kg
Code, emergency key
4 mm
1.5 mm
4 × AA LR6 (Mignon)
8