Herholdt Controls ECS3-1 Basic Betriebsanleitung Seite 2

Page 1:
In this page the value of the currently growing 3-phase Active Energy
is represented (or the last one that has grown).
The energy may be Active Consumed (right row), Active Generated
(left row), with Tariff T1 or T2, depending on the current
Energy flowing arrow.
Page 2-3-4:
In the second third and fourth pages are represented
the remaining 3 energy registers.
Page 5:
In this page the CT ratio appears.
The CT ratio is modifiable, see the section CT Ratio.
Page 6:
This page changes depending on
the model
Page 6
• Model equipped with S0: In this
page the time on in ms of the S0
pulse appears. This value can be
altered, see the section Pulse
Output.
• Model equipped with M-Bus or
Modbus: In this page the Modbus
address or the M-Bus primary
address appears. This value can
be altered, see the section
Communication Address
Page 7:
This page changes depending on
the model
• Model equipped with S0: In this
page the number of pulses per
kWh, of the S0 output, appears.
This value can be altered, see the
section Pulse Output.
• Model equipped with M-Bus or
Modbus: In this page the
communication baud rate
appears. This value can be
altered, see the section
Communication Baudrate.
Page 8-9:
These pages are available only for the model equipped
with M-Bus. In these pages the Secondary address
appears. These address can range from 1 to 99999999,
hence requires 2 pages (the 1st for the 4 highest digit,
the 2nd for 4 lowest digit). In this example, its value is
68010643. See the section Communication Address.
Page 10:
You can read the index of firmware release.
Page 11:
The checksum is periodically calculated to verify that the firmware
is reliable. The result of the calculation appears in this page.
Page 12:
All the display segment are visible.
Model S0
Page 7
Main Menu
Device Switch ON
Page 1
Page 2
Page 3
Page 4
Page 5
Model M-Bus
Menu
Menu
Page 8
Page 9
Page 10
Page 11
Page 12
- 2 / 12 -
"ECS3-1B - BASIC"
Menu
Menu
Menu
Menu
Menu
Model Modbus
Menu
Menu
Menu
Menu
Menu
Menu
Menu
Whichever the page on the
display, if no key is pushed for at least
20 sec., the main page appears again.
Menu
Menu