Installation; Unpack The Machine; Assemble The Machine; Install The Battery Pack - GreenWorks VUG403 Bedienungshandbuch

EN
At the end of their useful life, discard batter-
ies with a precaution for our environment.
The battery contains material that is danger-
ous to you and the environment. You must
remove and discard these materials separate-
ly at a location that accepts lithium-ion bat-
teries.
7

INSTALLATION

• Replace the battery pack or the charger immediately if the
battery pack or charger cord is damaged.
• Exam that the machine is in the OFF status before you
install or remove the battery pack.
7.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If parts of the machine are damaged, do not use the
machine.
• If parts are missing, do not operate the machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
For your personal safety, do not insert battery before the
tool is assembled completely.
7.2

ASSEMBLE THE MACHINE

To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
machine when assembling parts.
Figure 1-2
1. Insert the stick vac motor (1) into the extension tube (3).
The extension pole is installed when you hear a "click".
2. Insert the extension pole into the motorized brush
head(4). The floor brush is installed when you hear a
"click".
WARNING
WARNING
WARNING
WARNING
English
You can change accessories (9/10/11/12) according to your
cleaning needs. Push the release button (8) to unlock the
floor brush or extension pole, then choose your desired
cleaning tool for attachment.
7.3

INSTALL THE BATTERY PACK

Figure 3
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, understand, and follow the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
7.4

REMOVE THE BATTERY PACK

Figure 3
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
8

OPERATION

Do not handle battery pack, switch, or machine with wet
hands. Do not expose to rain or allow liquid to enter the
motor compartment.
Wear eye protection during operation.
8.1

START THE MACHINE

Figure 4-5
Do not operate the machine without collection bin or filter.
1. Press the trigger (15) to start the machine. The machine
runs at normal mode.
2. Touch the speed button (17) on the screen to adjust the
mode. This machine has three modes (20).
3. The screen also shows the remaining run time and battery
capacity (16).
6
TIP
WARNING
WARNING
WARNING