Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setting the
planing depth
Sawdust removal
(Accessory*)
Parallel fence
(Accessory*)
Chamfering
depth gauge
(Accessory*)
Advice for
operation
Maintenance
ENGLISH
With setting wheel.
The notches represent 0,1 mm cutting
depth.
In setting "P" (parking) the planer blades
are recessed in the housing.
A dust bag or suction hose with adaptor
can be attached to the machine for
sawdust removal with an wet- and- dry
vacuum cleaner.
*Not included in standard equipment,
available as an accessory.
The planing/chamfering width can be set
on the scale after attaching the rip fence.
*Not included in standard equipment,
available as an accessory.
The chamfering depth of 0–16 mm can be
set on the chamfering depth gauge.
*Not included in standard equipment,
available as an accessory.
Never reach into the danger area of the plane when it is running.
Place the front page of the machine on to the worpiece and switch on, before the
planer blade touches the workpiese. The selv opening swivel guard closes itself
when the machine is lifted, but can laso be effected with lever and then guide evenly
over the workpiece.
The v–shape notch in the front of the supporting plate ensures safe chamfering of
edges.
To adjsut cutting depth first set on "P". Then adjust to the necessary setting
according to required chamfering depth.
The ventilation slots of the machine must be kept clear at all times.
If the shavings discharge is stained with resin, remove it with a cloth soaked in
turpentine substitute.
In order to guarantee constant readiness for operation, the machine should be
checked for worn carbon brushes at one of the AEG after–sales service agencies.
Use only AEG accessories and spare parts. Should components need to be
replaced which have not been described, please contact one of our AEG service
agents (see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please state the ten–digit
No. as well as the machine type printed on the label and order the drawing at your
local service agents or directly at: Atlas Copco Electric Tools GmbH, Postfach 320,
D–71361 Winnenden.
4
H 500, H 750, HB 750, HBE 800
Werbung
