Clatronic hdr 2834 Bedienungsanleitung Seite 58

5....-05-HDR 2834 neu
Protection against Damage
GB
Please do not underestimate the pressure produced by the high-pressure cleaner.
If you would like to clean sensitive surfaces it is better to use the fan jet
(See "Adjustment of the Spray Jet" in the section "Operation"). In the case of paints
or insulated facades please begin at a considerable distance away. Move slowly clo-
ser - depending on the degree of soiling - to the object to be cleaned. Check the
progress of your work at short intervals in order to prevent damage. Never point
the high-pressure jet at other people, animals, the device itself or electrical
equipment!
Connection
1. Use a hose to connect the water connection (3) to the water supply.
2. Open the water supply and check for any leaks. A low level of water loss by the
pump is normal.
3. Insert the mains plug (9).
4. Turn the main switch (1) on.
Working with the Hand Spray Gun (8)
Switching on: Release the lock (10) and pull the lever of the gun. Caution! Recoil
Switching off: Release the lever. During work breaks secure the hand spray gun
(8) with the lock (10).
Adjustment of the Spray Jet
By turning the nozzle (5) you can vary the spray from a narrow jet to a fan jet.
Replacing Accessories
1. Turn the device off by the main switch (1).
2. Allow the pressure to escape by operating the lever on the manual spray gun
(8).
3. Change to the desired accessory and then continue operation of the machine.
Note: When the detergent container is being used it is not possible to obtain a
high-pressure effect.
Finishing Operation
1. Switch the device off by the main switch (1).
2. Remove the mains plug (9) from the socket.
3. Close the water supply.
4. Allow any residual pressure to escape by operating the lever on the manual
spray gun (8).
58
31.08.2004 12:12 Uhr
Operation
Seite 58