Herunterladen Diese Seite drucken

Commend ID5 DKHS Montageanleitung

Tisch-kit mit 45-neigung und handhörer für eine sprechstelle der indoor serie.

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

ID5 DKHS
Desk kit with 45° angle and handset for an Intercom station of the Indoor series.
Mounting
 Remove the protection film from the adhesive strip and stick the cable clip on the desk kit in a way
that the cut-out border forms a line with the housing (see illustration above).
  Guide the required cables through the opening on the rear of the desk kit (Ethernet cable and
USB cable of the handset).
 Connect the cables to the Intercom station.
 Put the Intercom station onto the desk kit, lower end first.
 Press the Intercom station onto the desk kit so that it snaps in place.
 Bend open the cable clip, guide through the USB cable of the handset and bend back the cable clip
so that the USB cable is fixed.
Extent of supply
• Desk kit
• USB handset
• Cable clip with adhesive strip
• Short reference
Technical data
IP rating:
IP40 (acc. EN 60529)
Microphone:
electret condenser microphone, polar pattern: omnidirectional
Frequency response (loudspeaker):
50 Hz to 7 kHz
Operating temperature range:
0 °C to +50 °C (+32 °F to +122 °F)
Storage temperature range:
−20 °C to +70 °C (−4 °F to +158 °F)
Relative humidity:
up to 90%, non-condensing
Connection:
USB 2.0 (Type A)
Power supply:
via USB, current consumption: < 0.5 A
Dimensions (H x W x D):
173 x 215 x 168 mm (6.81 x 8.46 x 6.61 in; with handset)
Weight incl. package:
approx. 900 g (2 lbs)
Colour:
graphite grey (RAL 7024)
1)
The USB connection is only intended for use with suitable Commend devices. Do not connect the USB plug e.g. to computers.
Installation instructions
• Do not place the device in areas where it may become wet or damp, and avoid dusty, humid and
high temperature environments (see "Technical data").
• Do not expose the device to direct sunlight.
• Do not place the device on unstable, uneven or vibrating surfaces.
• Do not make any modifications to the device.
• This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
ƒ Reorient or relocate the receiving antenna.
ƒ Increase the separation between the equipment and receiver.
ƒ Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
ƒ Consult the dealer or an experienced radio/TV technician for help.
Handling
Use the original packaging when transporting the device to prevent damage.
Disposal and recycling
Equipment with this symbol shall not be disposed of together with household or commercial
waste.
The directive 2012/19/EU on waste electrical and electronical equipment (WEEE) is applicable
in the European Union member states.
Manufacturer's reference
CE – This device complies with the directives listed below by fulfilling corresponding standards:
• Electromagnetic compatibility (directive 2014/30/EU)
• The restriction of the use of certain hazardous substances in electrical and electronic
equipment (directive 2011/65/EU)
FCC – For the FCC Rules, see "Installation instructions" .
Contact Commend USA: Commend Inc, 63 Ramapo Valley Road, Suite 201,
Mahwah, NJ 07430 (New York Area), www.commendusa.com
For technical specifications, see the respective data sheet.
For the latest software and documentation, visit: www.commend.com
Keep this description in safe custody.
Type: D-BZ-ID5-DKHS, Version: 1.5/0220
Commend International GmbH, Saalachstraße 51, A-5020 Salzburg – www.commend.com
coiled cord, cable length (not stretched out): approx. 300 mm (19.69 in)
1),

Werbung

loading

Inhaltszusammenfassung für Commend ID5 DKHS

  • Seite 1 Colour: graphite grey (RAL 7024) The USB connection is only intended for use with suitable Commend devices. Do not connect the USB plug e.g. to computers. Installation instructions • Do not place the device in areas where it may become wet or damp, and avoid dusty, humid and high temperature environments (see “Technical data”).
  • Seite 2 900 g Farbe: Graphitgrau (RAL 7024) Der USB-Anschluss ist nur für das Verwenden mit geeigneten Commend Geräten vorgesehen. Verbinden Sie den USB-Stecker keinesfalls z. B. mit einem Computer. Montagehinweise • Stellen Sie das Gerät nie an Orten auf, an denen es nass oder feucht sein kann. Vermeiden Sie außerdem Standorte mit Staubbildung, hoher Luftfeuchtigkeit oder hoher Umgebungstemperatur...