Marquant 014439 Bedienungsanleitung Seite 37

DISMANTLING
1. Remove the removable front panel.
See section Use – Fastening and
removing front panel .
2. Put the hooks on the removal tool in
the holes on each side of the decorative
frame and pull it out.
3. Put the removal tool in the slots on each
side and then follow the instructions
indicated with the arrows on the right.
FIG. 4
CONNECTION
Standard procedure
1. Switch off the ignition, remove the key
and disconnect the negative lead from the
car battery.
2. Connect the inputs and outputs on the
product.
3. Put the product in the vehicle.
4. Reconnect the negative lead to the battery.
5. Press the reset button on the product.
WARNING!
• The product can only be connected and
used in vehicles with a negatively
earthed 12 V electrical system.
• If the ignition lead (red) and battery
lead (yellow) are connected to the
chassis (earth) this can result in a short
circuit and fire. Always connect these
leads to the power supply via fuses.
• Disconnect the negative terminal on the
car battery and complete all the
electrical connections before installing
the main unit in the vehicle.
• Insulate non connected leads with
electrical tape or in some other safe
way. Do not remove the end caps from
the ends of leads or terminals not used
– risk of short circuit.
• Double check after installation that the
product is correctly earthed to the chassis.
• If the product does not start this could
be because of a short circuit in a speaker
lead, or because a speaker lead is
touching the chassis (earth), which trips
the safety function on the product. Check
the speaker leads for this reason.
IMPORTANT:
• If the ignition switch in the vehicle does
not have ACC mode the ignition leads
must be connected to a power source
that switches on and off with the
ignition key. The battery can be
discharged if the ignition leads are
connected to continuously live power
source.
• The product is intended to be installed in
the dashboard or centre console. Check
that the removable panel is not
obstructed by any covers on the
dashboard or centre console when they
are closed or opened.
• Check after installation and connection
that the brake lights, indicators,
windscreen wipers and other electrical
equipment are still working.
• The product should be installed at an
angle of no more than 30°.
• If the fuse trips, first check that no
uninsulated wires are touching each
other or the chassis (earth) to cause a
short circuit. Replace the fuse with a
new one of the same type.
• Connect the speaker leads to the correct
speaker terminals. The product can be
damaged or stop working properly if the
leads are short circuited or come in
contact with metal parts in the vehicle.
• If the hi-fi system only has two speakers,
both of them must be connected to
either the front or back speaker outlets.
Do not confuse front and back outlets.
EN
37