Lionelo Luna Bedienungsanleitung Seite 14

carrycot to secure the element with a distinct click (fig. 2). Mind the metal
tabs (A, fig. 2), which should engage the respective holes by pressing them in.
3.
Install the accessory basket (fig. 3). The assembly is secured when the
distinct click is heard. Mind the metal tabs (A, fig. 3), which should engage
the respective holes by pressing them in.
4.
Put the rubber loops of the accessory basket over the metal tabs (fig. 3a).
5.
Place the mattress in the crib (fig. 4).
6.
Pass the mounting straps under the carrycot through the respective holes
in the frame (fig. 5a), then into the buckles, and pull them taut (fig. 5b).
7.
The crib is correctly assembled.
Bedside sleeper function
To use the product as a bedside sleeper, it needs to be converted. The procedure:
1.
Undo the zippers on both ends of the folding side (fig. 7).
2.
Slide the locks (fig. 8a) to release the railing retainer (fig. 8b).
3.
Lower the folding side of the carrycot.
4.
Put the crib to the side of the adult's bed and set the crib's height so that
the top of the bed's mattress is level with – or no more than 2 cm above
– the top edge of the folding side.
Caution! When used as a bedside sleeper, the carrycot's bottom must be
parallel to the ground. There shall be no difference in height between the
crib's ends.
5.
Pass the crib's mounting straps under the bed's mattress and hook the ends
over the adult's bed frame on the opposite side of the bed. The ends must
be upright between the bed frame and the mattress.
6.
Secure the mounting straps to the crib using the clasps (fig. 10b).
7.
Tighten the mounting straps and make sure this keeps the crib stable and
firmly attached to the adult's bed.
CAUTION: Before each use, make sure there is no gap between the adult's bed
mattress and the side of the crib.
WARNING: This product can only be used with beds and/or mattresses which
have straight edges. Do not use this product with any beds and/or mattresses
which are rounded or with water beds.
EN ‑ 14 ‑