Commissioning - T.I.P. STEAM 25000 Original-Gebrauchsanweisung

5. Commissioning

The device must be transported in an upright position. If it is stored or transported horizontally, it
must stand upright for at least 24 hours before it may be switched on (Fig. 1).
Fig. 1
5.1 Placing of the heat pump
The device should be placed at least 2.5 m from the pool (Fig. 2).
Fig. 2
•
The future location of the device should be easily accessible for convenient operation and maintenance.
•
It must be placed on the ground, ideally on a level concrete floor. Ensure that the ground is sufficiently
stable and can support the weight of the device.
•
Ensure that the device is well ventilated, that the air outlet does not face the windows of neighbouring
buildings and that the exhaust air cannot flow back.
•
The device must not be installed when oil, flammable gases, corrosive products, sulphur -containing
compounds or high-frequency devices are nearby.
•
To avoid soiling, do not install the device near a road or path.
•
To avoid annoying neighbours, ensure that the device is installed facing the least noise-sensitive area.
•
Operate the device as far as possible out of the reach of children.
•
Leave a free space of at least 30 cm at the sides and rear of the heat pump (Fig. 3).
•
Do not place any objects in front of or on the device. A minimum distance of 1.5 m from the front of the
heat pump must be ensured.
Fig. 3
4
13