T.I.P. STEAM 25000 Original-Gebrauchsanweisung Seite 13

•
Parts of the packaging can be dangerous (e.g. the plastic bags) - therefore keep these out of reach of
children, people who not responsible for their actions and animals.
•
Only use accessories that are included in the scope of delivery, or only those that are specified in the op-
erating manual. The use of accessories that have not been approved may impair safety.
•
Any use of the device that is not described in this manual may be dangerous and must therefore be avoid-
ed.
•
The device must be correctly assembled with all parts before use. Check that the socket and plug match.
•
Never touch the mains plug with wet hands.
•
Switch off the device before maintenance, cleaning and after use, and unplug from the mains.
•
Do not leave the device within the reach of children or people who are not responsible for their ac-
tions.
•
Children should be supervised so that they do not play with electrical devices.
•
In case of incidents (e.g. contact with cleaning agents or chemicals) clean the machine with plenty of clean
water.
•
In the event of a malfunction, always pull out the mains plug to avoid any danger.
•
Carefully check whether the mains connection cable, housing or other parts of the device are damaged; if
so, do not use the device under any circumstances and contact the customer service department for re-
pairs.
•
If you are using extension cables, make sure that they are suitable for the application in question and that
they are placed on a dry surface and protected against water spray.
•
Service and repairs shall only be carried out by qualified personnel. Defective parts of the device shall only
be replaced with original parts.
•
The manufacturer is not responsible for any damage to persons or objects caused by improper use of the
device, or by a failure to follow the instructions provided in this manual.
1.1 Special safety instructions - Heat pump
•
Do not install near a heat source, combustible materials or building exhaust air.
•
If the installation is not in a location with restricted access, a heat pump protection grille must be fitted.
•
To avoid serious burns, do not touch the pipelines during installation or maintenance.
•
To avoid serious burns, switch off the heat pump before carrying out any work on the refrigerant system
and wait a few minutes before attaching temperature and pressure sensors.
•
Have the refrigerant level checked when servicing the heat pump.
•
Check that there are no traces of corrosion or oil stains around the refrigerant components.
•
Have the installation, initial commissioning and maintenance of the heat pump carried out by authorised
specialists only.
•
Do not start work on the heat pump until all safety instructions have been checked.
•
The device must be stable.
•
The electrical installation must function properly.
•
The hydraulic connections must be tight.
•
All unnecessary tools and objects must be cleared from the area.
Danger to life due to unsuitable water temperature!
Staying in pools with water temperatures that are too high or too low for a long time can cause overheat-
ing (body temperature above 38°C) or hypothermia (body temperature below 35°C). This can lead to fa-
tigue, dizziness, fainting or unconsciousness, resulting in death by drowning in the pool. Pregnant wom-
en run the risk of causing deformities or brain damage to their unborn child, especially in the first three
months of pregnancy.
•
Keep the water temperature in the range of 26-30°C during normal swimming operation.
•
Do not allow children and pregnant women to enter the water at water temperatures above 38°C.
•
Do not allow the water temperature to rise above 40°C.
•
If in doubt, check the water temperature with a suitable precision thermometer before entering the water.
(The temperature sensor of the heat pump guarantees an accuracy of approx. ±3°C.)
Fire and explosion hazard due to leaking heat exchanger fins!
The refrigerant circuit of the finned heat exchanger contains easily combustible, odourless gas under high
pressure. There is a risk of fire and explosion if refrigerant escapes in an uncontrolled manner.
•
Keep heat sources and open fires away from the heat pump.
•
Do not damage the device by drilling or setting fire to it.
•
Do not use any objects, except those permitted by the manufacturer, to accelerate the defrosting pro-
cess.
•
Shut down the heat pump immediately if you suspect refrigerant leakage and contact an authorised spe-
cialist.
•
The refrigerant is odourless. Always keep ignition sources away from the installation site of the heat
pump.
2
11