Zelmer ZKR1300W Benutzerhandbuch Seite 13

ANALYSIS OF COMMON PROBLEMS
Problem
The machine suddenly stops
working during use.
Turning the gear knob machine
does not run
Excessive noise when the machine
is running
The machine speed drops, or the
speed is unstable
Machine swaying and shaking
when working
The headstock can't spring back
to reset after putting on the an-
ti-splash cover and mixing bowl
Dough darkening found after use
Causes
It may be that the machine runs
too long, or the ambient tempe-
rature is too high, resulting in the
machine's motor temperature be-
ing too high; the machine starts the
overheating protection program,
automatic shutdown.
Check if the plug is in good contact
with the socket.
Check if the power is out.
Check if the rise button spring
back in place.
1 The machine will work louder in
high gear than in low gear.
2 The amount of food stirred is too
large, resulting in overloading the
machine.
3 Voltage is unstable.
4 Working time is too long.
1 Whether the room temperature
is low, causing the lubricant in the
machine to harden.
2 The ingredients stirred are too
hard and too much, resulting in too
much load on the machine.
3 Whether the voltage suddenly
becomes low.
1 Check if the foot pad on the base
is off.
2 Whether the machine is placed
on a smooth and flat countertop
for use.
Check that the anti-splash cover
is in place and the mixing bowl is
assembled.
Black powder falls onto the dough
at the mixing head.
PL
Solutions
Gear reset to "0", unplug the
power, wait for the machine to
return to room temperature can be
restarted (generally need 15-30
minutes, the room temperature
varies cooling time).
Verify that the power plug is plug-
ged into the outlet
Wait for power before operating
Make sure the headstock is stuck
in place.
1 Choose the right gear to stir food
according to the recommendations
in the manual
2 Reduce the amount of stirring.
3 If the voltage is unstable, wait
for the voltage to stabilize before
using.
4 If the working time is too long,
stop and cool down for a while
before using.
1 Remove the mixing bowl and let
the machine idle for 5 minutes to
soften the lubricant in the machine
and restore the speed stability.
2 Reduce the mixing volume and
let the machine work according to
the normal workload.
3 When the voltage is stable, use
the machine again.
1 Check if the foot pad on the base
is off.
2 Place on a smooth and flat coun-
tertop for use
Rotate the anti-splash cover and
assemble it in place, and assemble
the mixing pot in place.
Please check that the mixing head
and hook are dry and that no water
or dust is present on the surface
before use.
EN
13