Start And Stop Of The Machine (When Connected To A Water Supply); Start The Machine (When Connected To Open Containers (Suction Mode)); Pressure Regulation - Berner BHPC 150-2 4-in-1 Lance Betriebsanleitung

5.5 Start and stop of the ma-
chine (when connected
to a water supply)
5.6 Start the machine (when
connected to open con-
tainers (suction mode))

5.7 Pressure regulation

14
both hands.
IMPORTANT: Point the nozzle
at the ground.
1. Check that the machine is in
upright position.
NOTE: Do not place the ma-
chine in tall grass!
2. Release the trigger lock.
3. Activate the trigger of the
spray handle and let the wa-
ter run until all air has es-
caped from the high pressure
hose.
I".
5. Activate the trigger of the
spray handle.
Always adjust the distance and
thus the pressure of the nozzle
The washer can take in water
from a rain water tank as an
example. The hose for the wa-
approx. 5 m.
Make sure that the water tank is
not placed on a lower level than
the machine.
ter contains impurities.
1. Make sure that the water
water before connecting to
the machine. Place the entire
hose in a tank or bucket. To
High pressure
- cleaned.
Do not cover the machine
during operation.
Note: If the ma-
chine is left or
not used for 5
O".
2. Disconnect the electrical plug
from the socket.
activate the trigger to relieve
the machine of pressure.
4. Lock the spray handle.
When releasing the trigger of
automatically stops. The ma-
chine will start again when you
re-activate the spray handle.
the water inlet hose down in
the water and then connect
the hose to the machine with
uncrimp the water inlet hose.
lance and nozzle.
position I" and let the water
- from the water hose and the
pump.
O".
5. Mount spray handle and
thereafter lance.
I".
7. Activate the trigger of the
spray handle.
Flexopower Plus spray lance
The pressure can be regulated
on the Flexopower Plus spray
lance.
Original Instructions
O" (1):