Tesla Smart Sensor Gas TSL-SEN-GAS Benutzerhandbuch Seite 8

Using this Product
1. Preheating state
The product enters the preheating state after being powe-
red on. During the preheating period, the status indicator
is flashing yellow lights. After preheating is completed (no
more than 3 minutes), the status indicator will become
steady green.
2. Working state
When the product is working properly, the status indicator
will be steady green with no alarm sound.
3. Alarm state
If the product is working properly and the gas concentration
is higher than the preset alarm threshold, Red indicator is
flashing and the buzzer will generate an audible alarm.
4. Trouble Status
When detector is in trouble, yellow LED flashes, buzzer
beeps every 6-10s.
5. Simulation test
When the product is working, press the mute/self-diagnos-
tic button to enter the simulation test mode. After entering
the simulation test mode, the product will send a wireless
alarm signal. After the test is completed, the product will
send a wireless alarm clearance signal.
Routine Maintenance and Protection
To ensure that the product works properly, maintain and
protect the product as follows:
1. Correctly install, operate, and maintain the product in
accordance with the user manual.
2. Perform a self-diagnostic test on the product every
8