Network Setting - Tesla Smart Sensor Gas TSL-SEN-GAS Benutzerhandbuch

Network Setting

1.After power on, the detector will preheat for 1-3 minutes,
yellow LED flashes.
2. Press the reset button for 5S and release, the green LED
will flash for network setting.
Connect the product to the power supply.
• Network access status: Press the button for 5-10 seconds
to join a network. After pressed, the red indicator is steady
on, after 5 seconds release the button, the green indicator
flashes rapidly to start distribution of the network. If the
network access is successful, the green LED remains on for
5 seconds, the green light is always on, and the alarm enters
the normal monitoring state.
• If the product fails to enter the network configuration
mode within 60s, the status indicator will be steady yellow
for 5s and then off.
Press and hold
the button for 5s.
4